Sharp Notevision XG-MB67X Setup guide Download

Transcript
4. Adjust the projected image with the Setup Guide
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page 45.)
2 Follow the steps in the Setup Guide and adjust the focus, picture size, and height (angle).
3 After adjusting the focus, height (angle) and picture size, press TENTER to finish the Setup
Guide.
Quick Start
_P. 30
5. Turn the computer on
6. Select the INPUT mode
Select the “INPUT 1” using the INPUT button on the projector or C INPUT 1 on the remote
control.
On the On the remote On-screen display (RGB)
control
projector
• When pressing the INPUT button on the projector, input mode switches in the following
order: INPUT1 INPUT2 INPUT3 INPUT4
• When using the remote control, press the CINPUT 1/CINPUT 2/DINPUT 3/EINPUT
4 button to switch the INPUT mode.
_P. 32
7. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the projector
Shrinks
lower side.
Shrinks
upper side.
On the remote control
_P. 33
8. Turn the Power off
Press the STANDBY/ON button on the projector or the STANDBY button on the remote control,
and then press the button again while the confirmation message is displayed to put the projector
into standby mode.
On-screen Display
On the On the remote
control
projector
• Unplug the power cord from the AC outlet after the cooling fan stops.
_P. 29
17
XG-MB67XL_EN_CD_e
17
06.9.11, 6:45 AM