Sharp Notevision XG-MB67X Setup guide Download

Transcript
Setting up the Projector Network Environment (“Network” menu)
Menu operation n Page 40
Pict.
SCR
PRJ
Help
Network
Password
Disable
DHCP Client
On
TCP/IP
MAC Address
08:00:1F:B1:B7:74
Projector
XG-MB67X-L
SEL./ADJ.
ENTER
END
1 Setting a Password
If you do not want others to change the setting
for the “Network” menu, set a password.
a Setting a Password
1
Select “Password”, then press
hENTER or Q.
• The screen for entering the password
appears.
2
Enter the password in “Old Password” using P, R, Q and O, then
press hENTER.
3
Enter the password in “New Password” using P, R, Q and O, then
press hENTER.
4
Enter the same password again in
“Reconfirm” using P, R, Q and O,
then press hENTER.
Network
Setting the Password
– – – –
– – – –
– – – –
Old Password
New Password
Reconfirm
2
Press P or R to set the first digit
in “New Password”, then press Q.
3
Enter the remaining 3 digits, then
press hENTER.
• To return to the previous digit, press O.
4
Enter the same password in “Reconfirm”, then press hENTER.
Note
• Once after the password is set, you must enter the password to change the “Network”
menu settings.
a Changing the Password
1
Select “Password”, then press
hENTER or Q.
• The screen for entering the password
appears.
If you forget the password
If you forget the password, perform the following procedure to delete it, then set a new
password.
On the projector, press
S→T→S→T→S→T→U.
Useful
Features
• The status for “Password” changes to
“Enable”.
Note
• If you do not need the password protection
for the “Network” menu settings anymore,
press hENTER without entering new password in steps 3 and 4.
• To cancel the password settings, press l
RETURN.
Note
• If TENTER is held down for more than 5
seconds, the operation buttons on the projector will be locked. (See page 48.)
• You cannot use the buttons on the remote
control to delete the password.
49
XG-MB67XL_EN_CD_k
49
06.9.11, 6:50 AM