Download Bosch 4412 User guide

Transcript
Security System User’s Guide
Change a Passcode (Cmd 55)
I can perform this command.
I cannot perform this command.
Use this command to change your passcode at any time. Only use this
feature under the direction of your security company. Write down
your old passcode and the new one before you begin.
1.
Make sure that your system is off (All and Part indicators are off).
2.
Press [Cmd] + [5] + [5]. The Command Center flashes the Cmd
indicator to prompt you to enter your passcode.
3.
Enter your current passcode. The Command Center lights your user
number (1-16).
4.
Enter a new passcode with the same number of digits as your old
passcode. If the error tone sounds, try a different new passcode.
5.
Enter your new passcode again.
6.
The Command Center sounds the OK tone and returns to the off
state. You successfully changed your passcode.
LED Command Center User’s Guide
Copyright © 2002 Radionics
Page 23
46840C