Download Siemens RUGGEDCOM RSG2200 User guide

Transcript
Chapter 5
RUGGEDCOM ROS
Setup and Configuration
User Guide
1
2
3
4
5
6
Figure 93: MicroLok Form
1. Transport Options
3.
2. IP Port Box
3. Link Stats Options
4. DSCP Box
5. Apply Button
6. Reload Button
Configure the following parameter(s) as required:
Parameter
Description
Transport
Synopsis: { TCP, UDP, Disabled }
Default: UDP
The network transport used to transport protocol data over an IP network.
IP Port
Synopsis: 1024 to 65535
Default: 60000
A local port number on which the MicroLok protocol listens for UDP datagrams or TCP
connections.
Link Stats
Synopsis: { Disabled, Enabled }
Default: Enabled
Enables link statistics collection for this protocol.
DSCP
Synopsis: 0 to 63
Default: 0
To set the DS byte in the IP header. DS byte setting is supported in the egress direction
only.
4.
Click Apply.
Section 5.4.12
Configuring the DNP Protocol
To configure the DNP protocol for a serial port, do the following:
138
1.
Make sure the serial port is configured to use the DNP protocol. For more information, refer to Section 5.4.5,
“Configuring a Serial Port”.
2.
Navigate to Serial Protocols » Configure Protocols » Configure DNP Protocol » Configure DNP. The
DNP form appears.
Configuring the DNP Protocol