RUGGEDCOM ROS Chapter 5 User Guide Setup and Configuration Parameter Description IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255 Default: The IP address of the remote host. IP Port Synopsis: 1 to 65535 or { Unknown } Default: 50000 The IP port that remote host listens to. If this is zero (Unknown), the unit only receives from the remote host but does not transmit to it. Port(s) Synopsis: Any combination of numbers valid for this parameter Default: All The local serial ports that the remote host is allowed to communicate with. 4. Click Apply. Section 5.4.16.3 Deleting a Remote Host To delete a remote host used by the Raw socket protocol, do the following: 1. Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Remote Hosts. The Remote table appears. Figure 104: Remote Table 2. Select the remote host from the table. The Remote form appears. Deleting a Remote Host 147