Canon MP270 series Instruction manual Download

Transcript
An Error Code Is Displayed on the LED
Page 573 of 678 pages
device before connecting it to the machine.
You may also have to turn on your device or
select Play mode manually after connecting
the device to the machine. Perform
necessary operations before connecting
your device referring to its instruction
manual.
If the error is still not resolved, check if you
can print another photograph.
E, 1, 3
Ink level cannot be
detected.
Ink may have run out.
The function for detecting the remaining ink
level will be disabled since the ink level cannot
be correctly detected.
If you want to continue printing without this
function, press the machine's Stop (Reset)
button for at least 5 seconds.
Canon recommends to use new genuine
Canon cartridges in order to obtain optimum
qualities.
Please be advised that Canon shall not be
liable for any malfunction or trouble caused by
continuation of printing under the ink out
condition.
E, 1, 4
The FINE Cartridge cannot
be recognized.
The FINE Cartridge may not be compatible with
this machine.
Install the appropriate FINE Cartridge.
Routine Maintenance
E, 1, 5
The FINE Cartridge cannot
be recognized.
The FINE Cartridge may not be installed
properly.
Open the Scanning Unit (Cover) and install the
FINE Cartridge properly.
Routine Maintenance
E, 1, 6
Ink has run out.
Ink has run out.
Replace the ink cartridge and close the
Scanning Unit (Cover).
If printing is in progress and you want to
continue printing, press the machine's Stop (
Reset) button for at least 5 seconds with the
ink cartridge installed. Then printing can
continue under the ink out condition.
The function for detecting the remaining ink
level will be disabled.
Replace the empty ink cartridge immediately
after the printing. The resulting print quality is
not satisfactory, if printing is continued under
the ink out condition.
E, 1, 9
(MP270 series
only)
PictBridge compliant device
is connected via a USB
hub.
If a PictBridge compliant device is connected
via a USB hub, remove the hub and connect it
directly to the machine.
E, 3, 0
The size of the original
cannot be correctly
detected or the document
is too small when the Fit-toPage copying is selected.
E, 3, 1
The machine is not
connected with the
computer.
Connect the machine and the computer with a
USB cable.
E, 5, 0
Scanning the print head
alignment sheet has failed.
Press the Stop/Reset button to dismiss the
error, then take the actions described below.
Make sure that the original meets the
requirements and is correctly loaded on the
Platen Glass.
Check the position and direction of the
original loaded on the Platen Glass.