Download Motorola MVME712AM Installation guide

Transcript
Introduction
Requirements
These boards are designed to conform to the requirements of the following
documents:
❏
VMEbus Specification (IEEE 1014-87)
❏
EIA-232-D Serial Interface Specification, EIA
❏
SCSI Specification, ANSI
❏
IndustryPack Specification, GreenSpring
Features
❏
25MHz 32-bit MC68040 or MC68LC040 Microprocessor
❏
1 MB, 4 MB, or 8 MB of shared DRAM with parity protection
❏
512 KB of SRAM with battery backup
❏
One JEDEC standard 32-pin PLCC EPROM socket (EPROMs may be
shipped separately from the MVME162)
❏
One Intel 28F008SA 1M x 8 Flash memory device or four Intel 28F020 256K
x 8 Flash memory devices (1 MB Flash memory total)
❏
8K by 8 Non-Volatile RAM and time of day clock with battery backup
❏
Four 32-bit Tick Timers (in the MCchip ASIC) for periodic interrupts
❏
Two 32-bit Tick Timers (in the VMEchip2 ASIC) for periodic interrupts
❏
Watchdog timer
❏
Eight software interrupts (for MVME162 versions that have the
VMEchip2)
❏
I/O
❏
–
Two serial ports (one EIA-232-D DCE; one EIA-232-D or EIA-530
DCE/DTE)
–
Serial port controller (Zilog Z85230)
–
Optional Small Computer Systems Interface (SCSI) bus interface with
32-bit local bus burst Direct Memory Access (DMA) (NCR 53C710
controller)
–
Optional LAN Ethernet transceiver interface with 32-bit local bus
DMA (Intel 82596CA controller)
–
Four MVIP IndustryPack interfaces
VMEbus interface
–
MVME162IG/D2
VMEbus system controller functions
1-5
1