Overview of alarms 06/2007 Cycle alarms 61123 Channel %1 Block %2: CYCLE72 cannot be simulated Parameters: %1 = Channel number %2 = Block number, label Definitions: Alarm triggered by following cycle: CYCLE72. Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Program Continuation: 61124 Clear alarm with the RESET key. Restart part program Channel %1 Block %2: Infeed width is not programmed Parameters: Definitions: Source (cycle): CYCLE71 Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: In active simulation without a tool, a value for the infeed width _MIDA must always be programmed. Program Continuation: Clear alarm with the RESET key. Restart part program 61125 Parameters: Channel %1 block %2: Technology selection in parameter _TECHNO incorrectly defined %1 = Channel number %2 = Block number, label Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840. Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Check parameter _TECHNO. Program Continuation: Clear alarm with the RESET key. Restart part program 61126 Channel %1 block %2: Thread length too short Parameters: %1 = Channel number %2 = Block number, label Definitions: Alarm triggered by following cycle: CYCLE840. Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Program lower spindle speed/raise reference plane. Program Continuation: Clear alarm with the RESET key. Restart part program 61127 Parameters: Channel %1 block %2: Wrong definition of tapping axis transformation ratio (machine data) %1 = Channel number %2 = Block number, label Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840. Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis. 2-280 " Siemens AG 2007 All Rights Reserved SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition