Download Siemens SINUMERIK 802D sl Specifications

Transcript
Overview of alarms
06/2007
NCK alarms/ISO alarms
10602
Channel %1 block %2 velocity limitation during thread cutting
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In the displayed thread block, the axis would exceed its maximum velocity when the spindle override
is in the maximum position.
Reaction:
Local alarm reaction.
Alarm display.
Remedy:
If the axis velocity is not limited (faultless thread) no remedial measures are necessary. Otherwise, a
lower spindle speed must be programmed for the thread block.
Program Continuation:
Clear alarm with the Delete key or NC START.
10604
Channel %1 block %2 thread lead increase too high
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The thread lead increase cause axis overload.
A spindle override of 100% is assumed during verification.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Reduce the spindle speed, thread lead increase or path length in the part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
10605
Channel %1 block %2 thread lead decrease too high
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The thread lead decrease is causing an axis standstill in the thread block.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Reduce the thread lead decrease or path length in the part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
10607
Channel %1 block %2 thread with frame not executable
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The current frame is corrupting the reference between the thread length and the thread lead.
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Perform thread cutting with G33, G34, G35 without frame
Use G63 or G331/G332.
Program Continuation:
Clear alarm with the RESET key. Restart part program
10610
Parameters:
2-58
Channel %1 axis %2 not stopped
%1 = channel number
%2 = block number, label
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition