Download Siemens SINUMERIK 802D sl Specifications

Transcript
06/2007
Overview of alarms
NCK alarms/ISO alarms
10784
Channel %1 block %2 illegal tool for tool radius compensation with
constraint surface
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
When activating the tool radius compensation with constraint surface, an illegal tool type is active.
Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:
• 111 ball end milling cutter
• 155 Bevel cutter
• 156 Bevel cutter
• 157 Bevel cutter
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Use a different tool.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
10790
Channel %1 block %2 plane change during linear programming with
angles
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The active plane was changed between the first and second subblock when programming two straight
lines with angle parameters.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
10791
Channel %1 block %2 invalid angle during linear programming
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
No intermediate point was found when programming a contour consisting of two straight lines and an
angle specification.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
10792
Channel %1 block %2 illegal interpolation type during linear
programming with angles
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
Only spline or linear interpolation is permitted for programming two straight lines with angle specification. Circular or polynomial interpolation is not allowed.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition
2-77