Agilent Technologies 2000 X-Series Technical data Download

Transcript
1
What's New
Changed
Commands
Obsolete
Commands
36
Command
Description
:TRIGger:LEVel:HIGH (see
page 596)
Sets runt and transition (rise/fall time) trigger high level.
:TRIGger:LEVel:LOW (see
page 597)
Sets runt and transition (rise/fall time) trigger low level.
:TRIGger:PATTern Commands
(see page 616)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:DURation subsystem.
:WGEN Commands (see
page 663)
Commands for controlling the built-in waveform generator (with
Option WGN license).
:WMEMory<r> Commands
(see page 693)
Commands for reference waveforms.
Command
Differences From InfiniiVision 7000B Series Oscilloscopes
:ACQuire:MODE (see
page 187)
There is no ETIMe parameter with the 2000 X-Series
oscilloscopes.
:CALibrate:OUTPut (see
page 211)
The TRIG OUT signal can be a trigger output, mask test failure,
or waveform generator sync pulse.
:DISPlay:DATA (see page 258)
Monochrome TIFF images of the graticule cannot be saved or
restored.
:DISPlay:LABList (see
page 260)
The label list contains up to 77, 10-character labels (instead of
75).
:DISPlay:VECTors (see
page 262)
Always ON with 2000 X-Series oscilloscopes.
:MARKer Commands (see
page 317)
Can select reference waveforms as marker source.
:MEASure Commands (see
page 333)
Can select reference waveforms as the source for many
measurements.
:SAVE:IMAGe[:STARt] (see
page 429)
Cannot save images to internal locations.
:TRIGger:PATTern (see
page 617)
Takes <string> parameter instead of <value>,<mask>
parameters.
:WAVeform:SOURce (see
page 649)
Can select reference waveforms as the source.
:VIEW (see page 182)
PMEMory (pixel memory) locations are not present.
Obsolete Command
Current Command Equivalent
Behavior Differences
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide