Download Agilent Technologies 2000 X-Series Technical data

Transcript
23 :RECall Commands
:RECall:SETup[:STARt]
(see page 790)
Command Syntax
:RECall:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:SETup[:STARt] command recalls an oscilloscope setup.
NOTE
See Also
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
• "Introduction to :RECall Commands" on page 417
• ":RECall:FILename" on page 419
• ":SAVE:SETup[:STARt]" on page 438
422
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide