Download Agilent Technologies 2000 X-Series Technical data

Transcript
25 :SBUS<n> Commands
:SBUS<n>:SPI:CLOCk:SLOPe
(see page 790)
Command Syntax
:SBUS<n>:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SBUS<n>:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:SBUS<n>:SPI:CLOCk:SLOPe?
The :SBUS<n>:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
• "Introduction to :TRIGger Commands" on page 589
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 497
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 499
496
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide