Download Bosch LTC 8555 Instruction manual

Transcript
LTC 8600 | LTC 8800 Series
en | 79
User Function 31 - Set Printer RS-232 Parameters
This function is used to set the RS-232 baud rate and handshake options for the system's printer port. Upon entry to the mode, the current settings are displayed. Move
the joystick up/down to select the baud rate, and left/right to select the handshake
option. After being changed, the port is also automatically set to eight data bits, no
parity, and one stop bit. Once new settings have been selected, enter the user password and press [Enter]. If using the LTC 8555 Series keyboard, press [User] to exit.
User Function 32 - Set Alarm RS-232 Parameters
Use this function to select the RS-232 baud rate and handshake options for the system's alarm port. Upon first entering the mode, the current settings will be displayed. Moving the joystick up/down selects the baud rate. Moving the joystick left/
right selects the handshake option. After being changed, the port is also automatically set to eight (8) data bits, no parity, and one stop bit. Once the new settings
have been selected, enter the user password and press [Enter]. Press [User] to exit
the mode.
User Function 33 - Display User Number and Priority
This function displays the current user's number and priority level on the monitor
screen. The user number will be displayed on the top line and the user's priority
level will be displayed on the bottom line of the monitor screen. If using the LTC
8555 Series keyboard, press [User] to exit.
User Function 34 - Camera Indicator
This function is used to enable an onscreen indicator to identify a pan/tilt equipped
camera. Move the joystick up or down to select DISP CAM CONTROL or NO CAM
CONTL DISPL. Press [Enter] to activate your selection. When enabled, cameras identified as controllable (via User Function 35 or the optional LTC 8059/00 MCS package), show a
in the middle of the first line of monitor text.
User Function 35 - Controllable Cameras
Priority 1 users can use this function to select camera sites equipped with pan/tilt
devices. Move the joystick up or down to select the camera number, and left or right
to select FIXED or MOVABLE. User Function 34 or the optional PC software package
enables or disables the display of the controllable camera indicators on the system
monitor displays.
User Function 36 - Select Crosspoint Data
Use this function to select options for accessory device data that can be sent out
the biphase control port. Move the joystick up or down to select XPOINT DATA,
ALARM XPOINT, or PHYSICAL CAMERA NUMBER, and left or right to enable/disable
the selected option. These options are typically applicable only when LTC 8770
Series Switcher Follower accessory devices are being used in the system.
User Function 37 - R/D Address Mode
Priority 1 users can use this function to select whether the biphase control data
commands will be addressed using the cameras' logical numbers or physical number indexes in the Camera Table. Move the joystick up or down to select LOGICAL or
PHYSICAL and press [Enter] to activate your selection. If this option is set to LOGICAL, AutoDome Series cameras and Allegiant Series receiver/drivers should be
addressed using the cameras' logical identification number. If it is set to PHYSICAL,
the devices should be addressed using the cameras' physical port number.
F.01U.127.393 | 2.0 | 2009.03
Instruction Manual
Bosch Security Systems, Inc.