Download Agilent Technologies 6834B User`s guide

Transcript
3 - Language Dictionary
OUTPut:COUPling
Agilent 6811B, 6812B, 6813B, Only
This command enables ac or dc output coupling. When the output coupling is set to AC, a dc leveling loop
attempts to maintain zero average output voltage. The loop has a corner frequency of about 2Hz. It will not
prevent short transient waveforms that may have non-zero average voltage, but will cause a settling
transient to an average value of 0 volts.
The output coupling must be set to DC to obtain dc output with VOLTage:OFFSet, or to generate output
transients that have net dc components.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:COUPling <coupling>
AC | DC
AC
OUTP:COUP DC
OUTPut:COUPling?
<CRD>
*RCL *SAV
OUTPut:DFI
This command enables or disables the discrete fault indicator (DFI) signal to the ac source.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:DFI[:STATe] <bool>
0 | 1 | OFF | ON
OFF
OUTP:DFI 1
OUTP:DFI ON
OUTPut:DFI[:STATe]?
0|1
OUTP:DFI:SOUR
OUTPut:DFI:SOURce
This command selects the source for DFI events. The choices are:
QUEStionable
OPERation
ESB
RQS
OFF
Questionable summary bit
Operation summary bit
Standard Event summary bit
Request Service summary bit
Never true
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
56
OUTPut:DFI:SOURce <source>
QUEStionable | OPERation | ESP | RQS | OFF
OFF
OUTP:DFI:SOUR OPER
OUTPut:DFI:SOURce?
<CRD>
OUTP:DFI