Download Diamond Multimedia Viper V700 SERIES User`s guide

Transcript
2. Move jumpers J1, J2, J3 to the closed position:
Jumper J1-3, open position,
Jumper J1-3, closed position,
Your card is now set to the AGP 4X configuration.
Before You Install Your Card…
Before you install your Viper card, it is recommended that you set your display
driver to Standard VGA before you shut down your computer and remove your
legacy (AGP, PCI, or ISA) VGA card.
Setting the Standard VGA Under Windows 95
To set your display to Standard VGA under Windows 95:
1. From the Start menu, go to Start > Settings> Control Panel, then double-click
on Display. The Display Properties sheet appears.
2. Click on the Settings tab, then press the Advanced Properties button.
3. Click on the Adapter tab, the press the Change button. The Select Device window
appears.
4. Click on the Show All Devices bullet. Under Manufacturers select (Standard
Display Types). Under Models, select Standard Display Adapter (VGA).
5. Click on Apply, then click on OK in all windows to close and accept the changes.
6. Shut down your computer. You are now ready to remove your old graphics card
and install your new Viper V700 Series board.
Setting the Standard VGA Under Windows 98
To set your display to Standard VGA under Windows 98:
1. Select Start > Settings > Control Panel > Display. The Display Properties dialog
appears.
2. Choose the Settings tab and click on the Advanced button.
3. Click on the Adapter tab and click on the Change button. The Update Device
Wizard appears.
4. Click Next and select Display a list…
6