Download P2-80-12K40 - Stemmer Imaging

PRELIMINARY
P2-80-12K40 User’s Manual
67
Informal Message Codes
Code
Description
Suggested Cause
128
INFO: Calibration may be out-ofspecification (DO+FPN > 511)
ccf: at least one pixel -> FPN
INFO: Changing analog settings of
calibration mode voids pixel
calibration
sao, sg in calibration mode after
INFO: For better calibration results,
run FPN calibration first
ccp, cpa: ccp or cpa called before
ccf
256
512
coefficient > 511
calibration has been done
Monitoring Task Message Codes
Code
Description
Suggested Cause
1
WARNING: One or more
voltages out of specification
At least one of voltages is out of
specification
2
WARNING: Camera
temperature exceeds specified
limit
Current camera temperature exceeds
specification limit
4
WARNING: External SYNC not
detected
External SYNC not detected
16
WARNING: Analog gain is
over/under the specification
Current analog gain setting is out of
specification
B2 All Available Commands
As a quick reference, the following table lists all of the commands available to the camera
user. For detailed information on using these commands, refer to Chapter 3.
Parameters:
t = tap id
i = integer value
f = real number
s = string
[] = optional
parameter
DALSA
Command Mnemonic
Command
Parameters
Description
calibrate analog gain
cag
t i
Calibrates the analog gain to a
specified peak target value. The
first parameter is the tap selection
1 to 8, 0 for all taps. The second
parameter is the target value in a
range from 256 to 1004DN. Refer
to Calibrating Analog Offset and
Analog Gain Values on page 32
for details.
calibrate analog offset
cao
t i
Calibrates the analog offset to a
specified peak target value. The
first parameter is the tap selection
1 to 8, 0 for all taps. The second
parameter is the target value in a
range from 1 to 400DN. Refer to
Calibrating Analog Offset and
Analog Gain Values on page 32
for details.
03-32-10128-03