Download Click Here For the Amplicom TCL Vibe™ Instructions

TCL
VIBE
User
Guide
Contents
Features..............................................4
Functions.............................................6
Settings...............................................9
Important Safety Instructions
This alarm clock is designed to provide an acoustic alarm or alert signal at a set time. Any
other use is considered unintended use. Unauthorized modification or reconstructions is not
permitted. Do not open the device and attempt any repair work yourself.
Installation location
Prevent excessive exposure to smoke, dust, vibration, chemicals, moisture, heat and direct
sunlight.
Heart Pacemaker
Always maintain a distance of at least 6 inches from implanted heart pacemakers to prevent
any possible interference.
2
Instructions available in other languages at www.amplicomusa.com.
FCC
FCC Compliance
The FCC requires that you will be advised of certain requirements involving the use of this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved in writing by Amplicom may void the user’s authority to operate this
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a different circuit.
* Consult the dealer or an experienced radio/TV technician for help.
NOTE: Amplicom is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such
modifications could void the user authority to operate the equipment.
If you experience trouble with this equipment, please contact the Amplicom Service Center at 1-866-AMPLICOM (267-5426) for repair/
warranty information.
1-866-AMPLICOM (267-5426)
3
Features
Features
• Clock and calendar display
• Dual alarm clock and snooze
• Indoor temperature
• Low battery indicator
• Selectable alarm (audio, vibration or both)
• Wireless transmission to wrist alert
• Amber backlight
• Runs on 3 AAA batteries
4
Service Center
Layout
Clock Face Layout
1
5
2
3
1
Battery Indicator
2
Time
3
Alarms
4
Alarm Type
5
Temperature
4
1-866-AMPLICOM (267-5426)
5
Functions
Button Functions
When alarm is beeping or vibrating on wrist, press any button except for “SNOOZE” , and alarm will stop beeping and/or vibrating.
LIGHT/SNOOZE
• Activate light for 8 seconds
• Stop alarm temporarily for 5 minutes when alarm sounds or temporarily stop vibration on wrist
MODE/ENTER
• Single press to select the clock (Hour:Minute:Second), the clock (Hour:Minute:weekday), calendar, buzzer volume viewing, key tone on/off viewing, the unit auto returns to Hour: Minute Second display mode after viewing calendar or Buzzer volume viewing for 10 seconds)
• Press and hold for 2s to activate clock setting mode
NOTE: Press MODE 3 times and hold for 2s. When activated, display will flash. You have
10s to press up or down to select or the clock reverts back to the display.
6
Service Center
Functions
UP ARROW
• In clock setting mode, increase the setting value or select 12/24hr format or temperature unit or buzzer volume/frequency high/low;
• In alarm setting mode, increase the setting value or select alarm mode(audio alarm/vibration alarm/both/both not)
DOWN ARROW
• In clock setting mode, decrease the setting value or select 12/24hr format or temperature unit or buzzer volume/frequency high/low;;
• In alarm setting mode, decrease the setting value or select alarm mode(audio alarm/vibration alarm/both/both not)
ALARM
• Single press to cycles through ‘normal mode’, ‘alarm 1 view mode’, and ‘alarm 2 view mode’;
• In alarm 1/alarm 2 view mode, press and hold key for 2s to enter alarm 1/2 setting mode
1-866-AMPLICOM (267-5426)
7
Functions
RESET
Reset system, It is inside the battery compartment.
Alarm and Snooze Function
When the alarm 1/2 viewing display, press and hold ALARM 2s to enter the set mode of
alarm time. The sequence is Hour--- Minute ---alarm mode---exit.
When press UP or DOWN ARROW to modify the alarm time. Press and hold UP/DOWN
ARROW 2s to enter fast set the parameter.
When press UP or DOWN ARROW to select alarm mode, cycles through audio alarm →
vibration alarm → both → disable;
Press ALARM to enter next set parameter or exit.
When the alarm display, press UP or DOWN ARROW to select alarm mode, cycles
through audio alarm → vibration alarm → both → disable;
When the current time equal with the alarm time and the alarm function enable, the
unit will beep for 90 seconds, any key except for SNOOZE key will end the beep.
While the unit is beeping, if SNOOZE Motion is triggered, the unit will enter snooze,
the snooze time is 5 minutes. After 5 minutes, the unit will beep again.
8
Service Center
Settings
While the unit is beeping,
icon or the
icon is flash in [1Hz],
If alarm mode is in audio alarm mode, the alarm beep format is:
0 → 9s
[B] / s
10 → 29s [BB] / s
30 → 90s [BBBB] / s
If alarm mode is in vibration alarm mode, it will send RF packet every 0.5 second, The
wrist belt will vibrate when it has received the RF packet.
While snooze mode,
icon or the
icon is flash in [1Hz].
Settings
Press and hold MODE/ENTER 2s to set the clock at clock viewing screen.
The setting sequence as follow:
24Hr/12Hr → Hour → Min → Year → MD/DM → Month → Day → Language →
Temperature unit → Exit.(DCF version)
24Hr/12Hr → Hour → Min → Year → MD/DM → Month → Day → Language → Temperature unit → PMCE → DST on/off → Exit.(WWVB version)
Language set follow: English → German → French → Spanish → Italian
1-866-AMPLICOM (267-5426)
9
Settings
The desired setting will flash with [1 Hz], and press UP or DOWN ARROW to set the
conditions of operation. Press and hold UP/DOWN ARROW 2s to fast set these conditions.
Press and hold MODE/ENTER 2s to set the buzzer volume and frequency at buzzer
volume viewing screen.
Press UP or DOWN ARROW to select volume high or low, then press MODE to
confirm volume setting and set buzzer frequency
Press UP or DOWN to select buzzer high/low frequency, then press MODE to
confirm frequency setting and exit buzzer setting mode
Press and hold MODE/ENTER 2s to set the key tone on/off at key tone viewing screen.
Temperature Setting
Indoor:
10
The indoor temperature will sample every 30 sec.
The temperature range:
-10.0˚C (14.0˚F) → 60.0˚C (110.0˚F),
➢ > 60.0˚C, display “HH.H”;
➢ < –10.0˚C, display “LL.L”.
Service Center
Settings
Connect-check with Wrist unit
Transmitter: If alarm 1 or alarm 2 have been set with vibration, then press and hold DOWN ARROW 2S to send RF connect-check command, (include alarm 1 and alarm 2)
Transmitter: RF command will keep transmitting for 90s, press any key except for
SNOOZE to end connect-check with wrist unit
Transmitter: During connect-check with wrist unit,alarm 1 or alarm 2 icon will flash
Wrist unit: During connect-check with wrist unit, wrist unit also must enter connectcheck mode, this mode can be enter for 10s after power on
Wrist unit: If wrist unit has received connect-check command, it will check channel
number, then vibrate for 1s and flash red LED 4 times, it indicates that wrist unit is
connected with this transmitter;
1-866-AMPLICOM (267-5426)
11
General information
Default Settings
The display mode is Hour—Minute--Second.
Language: English.
The clock time is Jan 1,2012 0:00.
The alarm time is 0:00 and the alarm is disable.
The time format is 24 Hr (DCF) or 12Hr(WWVB).
The temperature unit is ˚C (DCF) or ˚F (WWVB).
Maintenance and Warranty
Maintenance
•
•
12
Please clean your equipment’s surfaces with a soft, lint-free
cloth.
Never use cleaning agents or solvents.
Service Center
Warranty
Warranty
AMPLICOM equipment is produced and tested according to the
latest production methods. The implementation of carefully chosen
materials and highly developed technologies ensure trouble free
functioning and a long service life. The terms of the warranty do not
apply where the cause of the equipment malfunction is the fault of
the telephone network operator or any interposed private branch
extension system. The terms of the warranty do not apply to the
rechargeable battery pack or power packs used in the products.
The period of warranty is 12 months from the date of purchase. All
deficiencies resulting from material of production faults which occur
during the period of warranty will be eliminated free of charge.
Rights to claims under the terms of warranty are annulled following
intervention by the purchaser or third parties. Damage caused as
a result of improper handling or operation, incorrect positioning or
storing, improper connection or installation, Acts of God or other
1-866-AMPLICOM (267-5426)
13
Warranty
external influence are not covered by the terms of warranty.
In the case of complaints, we reserve the right to repair or replace
defect parts or provide a replacement device. Replacement parts or
devices become our property.
Rights to compensation in the case of damage are excluded
where there is no evidence of intent or gross negligence by the
manufacturer.
If your equipment shows signs of defect during the period of
warranty, please return to the sales outlet in which you purchased
the AMPLICOM equipment together with the purchase receipt. All
rights to claims under the terms of warranty in accordance with this
agreement must be asserted exclusively with regard to your sales
outlet.
ONE year after the purchase of our products, claims under the terms
of warranty can no longer be asserted.
14
Service Center
Warranty
Included in the Box:
Clock
3 AAA Batteries
Travel Pouch
Wrist Band
Vibration Unit
Charge Cable
1-866-AMPLICOM (267-5426)
15
Questions?
Amplicom USA Service Center
3018 Ambrose Avenue
Nashville, TN 37207
V/TTY:
1-866-AMPLICOM (267-5426)
www.amplicomusa.com
Distributed by: Amplicom USA LLC
Made in China