Transcript
INTRODUCTION Thank you for choosing the Genaray LED-2100 On-Camera Light. This product will provide you with powerful, portable and dependable illumination that can be used in a variety of settings. Featuring advanced light dispersion capabilities and supporting accessories that add instant versatility to this light kit, the Genaray LED-2100 On-Camera Light proves to be the perfect choice for photographers and videographers alike. LED-2100 USER MANUAL KEY FEATURES PRODUCT CONTENTS · Integrated Shoe Mount Connects To DV & HDSLR Cameras 1 - LED Light With Built-In Diffuser & Shoe Mount · Unit Has 25' Lighting Range & 65° Illumination Angle 1 - Thread Adapter for Sony AIS Shoe Mount 1 - Included Camera Mounting Bracket · Stackable Mounting Feature Interlocks With Other Units 2 - 700mAh Li-Ion Rechargeable 1-Hour Batteries · Mounting Bracket Connects To 1/4 20 Camera Tripod Screw 1 - 110-240V AC/DC Wall Charger 1 - European Plug Adapter Built-In Diffuser Interlocking Expansion Slots 1/4 20 Threaded Mount Locking Ring Battery Compartment Cover Power Switch Cold Shoe Mount POWERING LED LIGHT MOUNTING LED LIGHT ON BRACKET · Open latch found on battery compartment cover by squeezing tab upwards; hold tab in upward position and remove the entire cover · Included mounting bracket is designed for point-and-shoot cameras that have no shoe mount; begin by mounting light on cold shoe found on bracket · Install fully-charged battery by sliding it into battery compartment; ensure that goldcolored battery conductor contacts face upwards and are touching metal prongs in the battery mounting area · Insert 1/4 20 screw found on bracket into the 1/4 20 threading mount found on bottom of camera; adjust spacing of camera by sliding knob along length of bracket arm and secure tightly · Replace battery compartment cover · Move the power switch into the ON position to illuminate the LEDs MOUNTING LED LIGHT ON CAMERA · Begin by positioning light unit directly atop camera or video camera SAFETY WARNINGS · Ensure that locking ring is fully loosened and slide cold shoe mount into shoe of camera; rotate ring clockwise to lock light into place securely · Do not attempt to disassemble, repair or perform any unauthorized modifications on device · Do not handle with wet hands, immerse in liquids or expose to water and rain; electric shock or fire may result · Device contains small parts which may pose a choking hazard; keep out reach of children · Do not operate device in presence of flammable gas or vapors · Do not use product if it emits smoke or a strange odor; disconnect power source immediately to avoid personal injury and contact place of purchase LED-2100 - USER MANUAL INTERLOCKING WITH OTHER LED UNITS · Ensure that device locking ring is fully loosened and slide cold shoe mounting into interlocking expansion slot of another compatible Genaray LED light unit; rotate ring clockwise to lock light in place securely · Up to 3 compatible Genaray LED light units can be mounted to each individual light unit or in a stacked vertical format for increased illumination · Observe caution when handling batteries; only use batteries approved by the manufacturer of this product · Batteries are prone to leakage when fully discharged; to avoid damaging product be sure to remove batteries when leaving product unattended · Do not intentionally stare or gaze at LED light panel for prolonged periods while device is on · Do not use or leave device in conditions of extreme heat, severe cold or high humidity · Unit will display a decrease in brightness when the battery runs low; be sure to replace battery when necessary to avoid affecting recording quality · When cleaning the device, use only a mild detergent solution and quickly wipe dry with a soft cloth · Please dispose of used batteries, packaging and old devices in accordance with appropriate environmental regulations CUSTOMER SUPPORT Please send email correspondence to: [email protected] LIMITED 1 YEAR WARRANTY See website for details www.genaraylighting.com MANUAL LED Array