Transcript
RGX620Z/620Z-D6 CONTROL SYSTEM QC71550 0112 Printed in Taiwan Volume Control Pickup Selector Front Pickup Front + Rear Rear Pickup Tone Control Output Jack RGX820Z CONTROL SYSTEM 1. To use magnetic pickup only, plug into output jack #1. 2. To use both magnetic & piezo pickup, plug into output jack #2. Battery Compartment * Battery needed to use output jack #2 Battery Compartment * No battery needed to use magnetic pickup only Piezo Pickup Bridge Volume Control (for output jack #1) Pickup Selector Pickup Selector Front Pickup Front Pickup Front + Rear Front + Rear Rear Pickup Rear Pickup Inside Knob: Tone Control Volume Control for output jack #2 Tone Control for magnetic pickup Outside Knob Output Jack #1 * Output only from magnetic pickup * Bypass pre-amp inside (passive) Panpot for magnetic/piezo * Clockwise for magnetic. Counter-clockwise for piezo Output Jack #2 * Output from magnetic & piezo pickup * Output through pre-amp inside (active) NOTE 1 Output jack #1 & #2 can be used at one time. NOTE 2 When not in-use, unplug from output jack #2 to save battery. Output jack #1 dose not consume battery. Changing the string on SPERZEL“Trim-Lok”tuner（RGX820Z） The SPERZEL “Trim-Lok” tuners offer easy string change and improved tuning stability when using the tremolo bridge. 1) Loosen the knob q on the back of the tuner. As the locking pin w in the string post goes down, remove the old string. e Loosen Tighten 2) Place the new string from the bridge into the string hole e of the string post. Do not wind the string around the post. 3) Pull the new string tightly and tighten the knob q to lock the string. 4) Tune the strings to the pitch. NOTE q Don't loose the knob q too much. It may drop out the tuner. Adjustment of tremolo unit ■ String Action Adjust the tremolo unit height by rotating the height adjustment bolts q. ■ Intonation Adjustment If the pitch at the 12th fret is sharp compared to the harmonic tone: → Turn the intonation adjusting screw w clockwise. If the pitch at the 12th fret is flat compared to the harmonic tone: → Tune the intonation adjusting screw w counter-clockwise. e q ■ Arm Tension Turn the arm tension screw e clockwise to make the arm tighter. Turn the arm tension screw e counter-clockwise to make the arm looser. w w
