Transcript
ASSEMBLY INSTRUCTION MANUAL MODEL: F41S DIP STATIO PARTS CHART !.':NO::,.~D~E~S:::C!::R!,,'P:,:T,:,:'O,:,:N,::-_ _---,Q..,TY+,' ~~\======'9""< 301 UPRIGHT FRAME 1 302 311 MIGHT SUPPORT 1-114" ROUND PLUG 1 2 301 312 313 321 322 323 50 SQ. END PLUG HAND GRIP 112" X 3" HEX HEAD BOLT 112" NYLON NUT 112" wo.SHER 2 311 2 3 A 3"- 6 321 114 1/2 3/4 (Inoh) ,~ 1/2 112 ,-;;- t/2 .. ~ 302 o "j) 312 313 • ~ 322 w W",I,!,I,!,I--'-7,LW ,I,I, r' o "",,,,,,,.~< . '" ". 323 ." The Dip attachment can attach to either side of the F410 Linear Smith. 1. Removed the two 8011$(20) attaching side Base Frame{l or 2) to the Rear Stabilizer (3). Discard the Connect Plate(14). Attach Upright frame(301) to Base Frame(1) and tighten Bolts(20), Washer(27) and Nut(29) again. 2.Atlach weight Support(302) onto Upright Frame(301). tighten three Bolls(321), six Washers(322) and three Nub(323). 3. VIet Hand Gr1J(313) and slide into the ~ Support(302). ".Attach Round P1ug(311) and End ClIf'{312) onto weight $upport(302). 3" '" • 302 "" Thank you for purcbasing the Bodycraft Smith Attachment Strength Training System. If You have any questions, please call your local BodyCraft dealer or call our customer service de artment at 801)..990-5556.