Transcript
TREE SEAT ASSEMBLY & INSTALLATION CR91169 Ultimate Swivel TS96-VS Slimline Figure 1 Figure 2 INSTALLATION - ALL SEATS: 1. Position seat in closed position (see fig. 1). 2. Place strap around tree (see fig. 1). CR91169 ASSEMBLY INSTRUCTIONS: 1. Remove 2" nut, bolt, and washers from the mainframe. 2. Making sure the strap is facing inward (toward the seat), insert post into grove on mainframe. 3. Reinsert bolt, washers and nut. Tighten securely. 3. Place buckle over S-hook (see fig. 2). 4. Pull strap through slide buckle until tight. 5. Lower seat into sitting position (see fig. 2). 6. If seat becomes loose, lift seat upright and retighten strap. TO REMOVE: 1. Lift seat to upright position. 2. Loosen by sliding strap back through buckle. 3. Remove seat from tree. WARNING: Tree Seats are to be used at a height that allows the feet to be on the ground at all times when in use. Use as a ground seat only! Failure to follow this warning may result in serious injury or death! PO Box 382 • 1820 N. Redding Avenue • Windom, MN 56101 Toll Free: 800-268-5077 • Website: www.biggametreestands.com