Transcript
AMPLIFIERS / 2-Channel Hookup This drawing shows the basic connections for a 2-channel amplifier. See Appendix A for other system related connections such as System Bus, DC distribution, or Low-Level and High-Level Bus. Amp (position. #4) DC Connections Switched + (Blue) Battery (Yellow) Ground (Black) 916X DC Power Adapter CAUTION! 916X 2 3 1 BAT– DISCONNECT BATTERY BEFORE SERVICING. 4 GND GND GND GND TURN ON TURN ON TURN ON TURN ON BAT BAT BAT BAT PUSH TO RESET BAT+ 3 System Bus Connections 2 1 2 Channel Amplifier PUSH TO RESET DC EXPANSION 56 4 23 0-9 01 10-19 SYSTEM BUS Left Right ASD DC EXPANSION Model 942 Amplifier Selector 1 2 3 4 PSB PSB AMP IN BUS Amp Output Left Right + – + – 916X DC Expander Connection Optional 994/995 Product Select Button SOURCES MODULE ID 4 56 23 9 78 01 Address Settings 9 78 GROUP S M B T D Settings for Bypass & Amp Turn On Delay Preamp Input POWER ON ON OFF 701-1086 S LEFT AUDIO Low Level Bus Connections (IN & OUT) Amp Input Pos. #4 RIGHT AUDIO Amp Output Pos. #4 High-Level Bus Connections ( L+ L– R+ R– ) SPEAKER OUTPUT FRONT, REAR, SUB, ETC: EXPANSION SPEAKER BUS Audio Signal Expansion Port Amp Bypass Note: This amp could not be connected in position #4 as shown if this were the last module in an Amplifier Product Group to be bypassed. 48 ASD Tech Support USA and Canada: 800-322-8346 (Mon-Fri 8:30 AM to 5:00 PM Eastern Time) Phone: 859-233-4599 Fax: 859-233-4510 Hookup drawings and FAQ http://www.audioauthority.com