Transcript
TRADITIONAL CHAMPION® 4 ELONGATED RIGHT HEIGHT™ ONE-PIECE TOILET VITREOUS CHINA TRADITIONAL CHAMPION® 4 ELONGATED RIGHT HEIGHT™ ONE-PIECE TOILET WITH SEAT ❑ 2034.004 •Vitreous china • EverClean® surface inhibits the growth of stain- and odor-causing bacteria, mold, and mildew on the surface •Low-consumption (6.0 Lpf/1.6 gpf) • Features Champion® 4 Flushing System performance platform •4" non-adjustable, piston action Accelorator™ flush valve •16-1/2" rim height for accessible applications •Elongated siphon action jetted bowl •2-3/8" fully-glazed trapway • Includes color-matched and design-matched slow-close molded wood toilet seat and cover with polished chrome hinges and EverClean® surface • Traditional styled polished chrome trip lever • Two matching styled polished chrome bolt caps • 100% factory flush tested •10 year warranty FINISHED WALL 44mm (1-3/4) 203mm (8) 756mm (29-3/4) C/L OF SEAT POST HOLES 140mm (5-1/2) CENTERS 470mm (18-1/2) Nominal Dimensions: 756 x 451 x 749mm (29-3/4" x 17-3/4" x 29-1/2") 25mm (1) SUPPLY AS REQ'D Fixture and seat only, supply by others Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixturesincludes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black ❏ Supply with Stop (by other): MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES. When installed, top of seat meets minimum requirement of 432 to 483mm (17" to 19") from the finished floor. • © 2008 AS America Inc. 425mm (16-3/4) 419mm (16-1/2) 95mm (3-3/4) 32mm (1-1/4) 273mm (10-3/4) 305mm (12) 13mm (1/2) 343mm (13-1/2) 451mm (17-3/4) 749mm (29-1/2) 178mm (7) *114mm (4-1/2) FINISHED FLOOR 273mm (10-3/4) C/L OF OUTLET NOTES: THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. * DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. K7 Revised 2/08
