Transcript
HERITAGE™ PEDESTAL SINK VITREOUS CHINA HERITAGE™ PEDESTAL SINK • Classic design with large, spacious deck space • Made from vitreous china • Rear overflow • Design-matched to Heritage toilets • Supplied with mounting kit ❏ 0191.134 Faucet holes on 8" (203mm) centers Nominal Dimensions: 762 x 514 x 864mm (30" x 20-1/4" x 34") Separate Components: ❏ 0191.643 Pedestal top-8" (203mm) centers ❏ 734700-400 Pedestal only Bowl sizes: 454mm (17-7/8") wide 295mm (11-5/8") front to back 165mm (6-1/2") deep Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures 743mm (29-1/4) 203mm (8) 73mm (2-7/8) FINISHED WALL 191mm (7-1/2) (3) 35mm (1-3/8) DIA. HOLES 514mm (20-1/4) 762mm (30) To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: 248mm (9-3/4) DRAIN CHASE 203mm (8) SLOTS FOR ANCHOR SCREWS 102mm (4) 102mm (4) 178mm (7) SUPPLIES AS REQUIRED 864mm (34) 1-1/4 O.D. WASTE OUTLET * See faucet section for additional models available 1-1/4 O.D. TAILPIECE 572mm *(22-1/2) 511mm *(20-1/8) n OPEN TO FLOOR FINISHED FLOOR (2) 11mm (7/16) ANCHOR BOLT HOLES NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE *SUGGESTED. ▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED. ■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST BE TAKEN FROM FIXTURE. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. J1 Revised 2/08