Transcript
ENFIELD™ COUNTERTOP SINK VITREOUS CHINA BARRIER FREE ENFIELD™ COUNTERTOP SINK • Decorative ogee rim detail round sink • Made from vitreous china • Self-rimming with cutout template supplied • Center drain outlet • Front overflow ❏ 0740.000 Round Sink less Faucet Deck Nominal Dimensions: 419mm (16-1/2") Round Bowl Sizes: 324mm (12-3/4") round 152mm (6") deep Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixture Shown with Hampton 8" Faucet (7881732.295) A 51mm (2) MIN. B C L of Faucet ** 610mm (24) 51mm (2) 38mm (1-1/2) MIN. FINISHED WALL OR SPLASH BACK 206mm (8-1/8) 203mm (8) MIN. 419mm (16-1/2) C/L 848mm (33-3/8) COUNTERTOP CUTOUT 384mm (15-1/8) DIA. DRAWING FOR DIMENSIONAL PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION. 686mm (27) MIN. COUNTERTOP (BY OTHERS) SEALING COMPOUND 152mm (6) MAX. 29mm (1-1/8) BARRIER FREE CLEARANCE 159mm (6-1/4) * 305mm 229mm (9) MIN. 787mm (31) SUGGESTED (12) * 254mm (10) SUPPLIES AS REQ'D. 203mm (8) 835mm (32-7/8) 178mm (7) FINISHED FLOOR 1-1/4 O.D. WASTE To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Black ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: 1-1/4 O.D. TAILPIECE * See faucet section for additional models available MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES - CHECK LOCAL CODES. Install lavatory 864mm (34") from finished floor. Lavatory installed 51mm (2") minimum from front edge of countertop provides 686mm (27") knee clearance area. © 2008 AS America Inc. FAUCET A B CENTER-SET 27mm(1-1/16) 102mm(4) SPREAD 32mm(1-1/4) 203mm(8) NOTES: * DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE SUGGESTED. SPOUT MUST BE 4-5/8" LONG (min.) FOR ADEQUATE CLEARANCE ** INTO SINK FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. IN-FIELD ADJUSTMENT OF POP-UP ROD EXTENSION REQUIRED. PROVIDE A 2-1/2" SEALING COMPOUND SUPPLIED BY OTHERS. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet. J34 Revised 2/08
