Download Amana Refrigerator PKB136R User's Manual
Transcript
PKB136L, PKB136R Integrated Bottom Mount Refrigerator Panel Kit Installation Instructions Introduction RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION CAUTION To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective material. Read entire manual before installing kit. Confirm all parts listed are included in kit. If parts are missing, contact source from whom kit was purchased. CAUTION To avoid personal injury and property damage, observe all safety instructions. Important CAUTION To avoid personal injury, protect hands and arms by wearing gloves while installing trim kit. • Mechanical experience is required to install trim kit. • Depending on installer’s knowledge and skill, installation can take from one-half to one hour. • If unable to solve a problem during installation, contact source from whom kit was purchased. Parts List PKB136RW PKB136RB Kit number PKB136RS PKB136LW Part Number PKB136LB PKB136LS 12339601 12339603 12339501 12339601 12339603 12339501 12339701 12339701 12339701 12339701 12339613 12339702 12339614 12339702 12339602 12339702 12339604 12339702 10599707 10599707 Not applicable 12339507 Not applicable 10599707 10599707 10599707 Not applicable 12339502 Not applicable 10599707 Description Refrigerator panel Refrigerator panel spacer Freezer panel Freezer panel spacer Installation instructions Procedure 1. Slide out refrigerator handle screw insert and remove handle by removing screws with a Phillips screwdriver. 4. Slide out handle screw insert from top of freezer drawer. Remove freezer drawer handle screws. Remove handle. Handle is in two pieces, reassemble if handle pieces come apart. Refrigerator handle Handle screw insert Handle screws Handle Handle screws Handle insert 2. Align panel in groove between top and bottom trim and push evenly. Start at one end and work across door. If panel binds loosen top door trim. Adjust panel and retighten. 5. Align panel in groove between left and right freezer drawer trim. Push evenly. If panel binds loosen Freezer drawer side trim. Adjust panel and retighten. Refrigerator handle Freezer drawer handle Decorator panel IMPORTANT: Do not remove corrugate from back of panels. Panels will not fit properly if corrugate is removed. • For ease of installation, two people are required to lift and guide panel into trim. Install one panel at a time. • For smoother installation apply bar soap on door trim and panel. 3. Reinstall handle with screws removed in step 1. Install handle screw insert by starting at one end and working upward along the full length of handle. Part No. 10599707 Printed in U.S.A. Decorator panel IMPORTANT: Do not remove corrugate from back of panels. Panels will not fit properly if corrugate is removed. • For smoother installation apply bar soap on door trim and panel. 6. Reinstall handle by replacing screws removed in step 4. Install handle screw insert by starting at one end and working across the full length of the handle. 7. Peel off protective film from the front of decorator panels. © 1997 Amana Amana, Iowa 52204