Download Amana Refrigerator PKB136R User's Manual

PKB136L, PKB136R
Integrated Bottom Mount Refrigerator Panel Kit
Installation Instructions
Introduction
RECOGNIZE THIS
SYMBOL AS A SAFETY
PRECAUTION
CAUTION
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material.
Read entire manual before installing kit. Confirm all parts
listed are included in kit. If parts are missing, contact
source from whom kit was purchased.
CAUTION
To avoid personal injury and property damage,
observe all safety instructions.
Important
CAUTION
To avoid personal injury, protect hands and arms by
wearing gloves while installing trim kit.
• Mechanical experience is required to install trim
kit.
• Depending on installer’s knowledge and skill,
installation can take from one-half to one hour.
• If unable to solve a problem during installation,
contact source from whom kit was purchased.
Parts List
PKB136RW PKB136RB
Kit number
PKB136RS PKB136LW
Part Number
PKB136LB
PKB136LS
12339601
12339603
12339501
12339601
12339603
12339501
12339701
12339701
12339701
12339701
12339613
12339702
12339614
12339702
12339602
12339702
12339604
12339702
10599707
10599707
Not
applicable
12339507
Not
applicable
10599707
10599707
10599707
Not
applicable
12339502
Not
applicable
10599707
Description
Refrigerator
panel
Refrigerator
panel spacer
Freezer panel
Freezer panel
spacer
Installation
instructions
Procedure
1. Slide out refrigerator handle screw insert and remove
handle by removing screws with a Phillips
screwdriver.
4. Slide out handle screw insert from top of freezer
drawer. Remove freezer drawer handle screws.
Remove handle. Handle is in two pieces,
reassemble if handle pieces come apart.
Refrigerator
handle
Handle screw insert
Handle screws
Handle
Handle
screws
Handle
insert
2. Align panel in groove between top and bottom trim
and push evenly. Start at one end and work across
door. If panel binds loosen top door trim. Adjust
panel and retighten.
5. Align panel in groove between left and right freezer
drawer trim. Push evenly. If panel binds loosen
Freezer drawer side trim. Adjust panel and retighten.
Refrigerator
handle
Freezer drawer
handle
Decorator
panel
IMPORTANT:
Do not remove corrugate from back of panels. Panels
will not fit properly if corrugate is removed.
• For ease of installation, two people are required to
lift and guide panel into trim. Install one panel at a
time.
• For smoother installation apply bar soap on door
trim and panel.
3. Reinstall handle with screws removed in step 1.
Install handle screw insert by starting at one end and
working upward along the full length of handle.
Part No. 10599707
Printed in U.S.A.
Decorator
panel
IMPORTANT:
Do not remove corrugate from back of panels. Panels
will not fit properly if corrugate is removed.
• For smoother installation apply bar soap on door
trim and panel.
6. Reinstall handle by replacing screws removed in step
4. Install handle screw insert by starting at one end
and working across the full length of the handle.
7. Peel off protective film from the front of decorator
panels.
©
1997 Amana
Amana, Iowa 52204