Download Aiphone NA-T/A User's Manual
Transcript
ve €» AIPHONE ( NEM Series в HANDSET SUB STATION моче: NA-T/A N INSTALLATION 8: OPERATION MANUAL 1 SYSTEM OUTLINE & COMPONENTS NA-T/A is a handset sub station for use with NEM, NEM-A Lamp Memory Intercom System. It can be used alone or in combination with any open voice sub (calling from the sub becomes inoperable). NEM-10, 20, 30, 40 NEM-10A, 20A, 30A, 40A Sg po к N Eon EA) Zod GS Y 7 , КИ ha y bh | il il | 1B be Аа CAL T T 7 B 2 > > E COMPONENTS * Master stations NEM 8 NEM-A Series Master stations NEM-10, 20, 30 & 40 NEM-10A, 20A, 30A 8 40A * Sub stations NA-A, NA-AN, NA-NE 8 NB-L 2 NAMES AND FEATURES || Handset — | Rubber foot Handset cradle Call-acknowledged LED Terminal section | H Features * Simple operation: telephone-type substation with automatic call-in. * Direct voice cali from the master station. * Simple wiring: two wires from substation to master. * Two-way open voice communication may be added using a standard. NA-A, NA-AN or NB-L substation. —1— 3 WIRING M Wiring diagram NEM-n NEM-nA “master (n=10, 20, 30, 40) NA-T/A mu 11 1 | 113 Ш 1214 X 12 2 F113 4 13 3 113 T El 2 | 4 | ET ; 14 (any) 4 NA-T/A 15 5 16 6 1 AID 24H B E 17 7 18 8 1/3 RED 214 BLACK 19 9 Green (jumper) 20 10 1 RED ne — 2 HBLACK = ES | — GREÉN a (any) NA-NE NA-T/A Remove a jumper on NA-T/A when attached to a standard open voice sub (any). NEM Lamp Memory Intercom NEM or NEM-A is a master-selective open voice press-to-talk or handset voice-actuation system. NA-T/A adds handset capability to an open voice sub, providing private communication. Cable Use a multi-conductor (non- twisted) cable 22AWG-18AWG, including 2 extension wires to standard sub attatched to each NA-T/A. With the jumper between terminals 3 & 4, a single NA-T/A can receive a pre-tone and voice transmission from the master station. Full two-way communication requires the use of the handset. When an NA-A or NB-L substation is used in conjunction with the NA-T/A as shown above, two-way open voice communication is possible. Lifting the handset disables the open voice sub station, allowing 2-way communication between the master and the NA-T/A. | Note 1; The jumper between the NA-T/A terminals 3 & 4 should be removed if used in conjunction with a standard substation, or distortion may result. Note 2; If background music is to be distributed through the system, the NA-T/A must be used in conjunction with a standard substation or distortion may result. Wiring distance * Select the proper wire gauge from the chart below to meet your requirements. AWG 22AWG 20AWG 18AWG Distance 420' 650" 4000" 4 MOUNTING * Do not attempt to install your intercom system until you have read and thoroughly understand the installation procedure. Aiphone's warranty is void if system is installed in a manner other than as described in this manual. | Cradie Mounting Single-gang bracket . box .. 83.5mm *. * | 3-5/16" Screw(2) NA-T/A Ш Wall-mounting | * Remove two screws from body and install handset cradle for handset with two screws. Remove wall hanging bracket from back of unit. Attach the bracket to wall or box. Connect wires and fit the unit onto the mounting bracket by sliding the unit down until it locks on the bracket. 5 OPERATIONS To place a call: Simply lift the handset and wait for the master station to answer. To answer a call through a single NA-T/A, simply lift the handset and talk. Receiving a call: A pretone and voice is heard when the sub is called by the master. Respond handsfree through the open voice sub (NA-A, AN, NB-L), or pick up the NA-T/A handeset for a private two-way conversation. Note; If the master station hangs up before the NA-T/A, a call tone may be heard at the master. Call tone will cease when the NA-T/A handset is hung up. O SPECIFICATIONS * Power source: Supplied by NEM (-A) master. x Calling: Pre-tone and voice on both NA-T/A and the standard sub. * Communication: Handset voice-actuation on NA-T/A, or handsfree, on standard sub (any). * Wiring: 1 common + 1 indiv. per NA-T/A. * Wiring distance: AWG 22AWG 20AWG 18AWG Distance 420' 650' 1000' x Dimensions (H x W x D): 232 x 94 x 105 mm 9-1/8" x 3-3/4" x 4-1/8" Xx Weight: 600g, 1.32 №65. fo eto ate ota ajo ote eto aja efe ojo aja oja ajo ojo ato ojo nto efe nto ojo ajo ota ajo ajo ojo ajo ajo aja ojo aja ojo ojo ojo ajo ola ajo fo ово +50 0e fo aja aja eje ajo ojo ajo eje ajo ajo ojo ajo ojo aja ojo aja ajo ajo ojo ajo ojo ojo aja ajo WARRANTY Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty. | This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries used in connection with the product. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone. Aiphone will not be responsible for any costs incurred involving on site service calls. ojo ote ote efe ojo ato ape ape af ajo aja ajo efe fo ajo ste ojo of ato ato фо оо фо обо обо обо оф efe ote oje ole ae fa aja aja fe ofe of of efe ato ato ato eto ojo fo ojo oferto ato aja fa ojo ojo fa te ofe oje oje ofe aie ein ERE FREER EEE EEE Fhe EEE bbb Ebb Aiphone Corporation, Bellevue, WA, USA Al PHON E HOME, BUSINESS, INDUSTRY. МА-Т/А-КЕ)0795В Printed in Japan (E) Aiphone Co., Lid., Nagoya, Japan oa COMMUNICATION SYSTEMS
Related documents