Transcript
Trouble Shooting:
Auto Multi=I?Cs
The reason for not compatible with IN NO EVENT THE DIRECT VENDOR'S LIABILITY EXCEED THE
; FRICE FAC FOR THE PRODUCT FROM DIRECT, INDIRECT,
Auto Multi-PCs Controller. SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES
1.The BIOS in the mother board. RESULTING FROM THE USE GF THE PRODUCT, DIST, OF ITS т
(Basic Input/Output System) a ea er Om ho el
2.The hardware equipment (Keyboard. Mouse) The direct wendor makes no warranty or representation, :
3.5oftware.05(Operating System) expressed, implied, or statutory with respect to the contents or
Use of this documentation, and specially disclaims its quality,
SITU ATIC xo Riel performance, merchantability, or fitness for any particular
purpose The direct vendor also reserves the right to revise or
Update device ordocumentation without obligation to update,
For further inquires please contact your direct vendor,
- Checlowhether the mouse install
mouse driver,
« Exchange other mouse,
(Fo/2 mouse only for User side] be и
Mouse Hanged « Connetthemouseto PC directly "reventinc Radio & TV Interference:
. Exchange the PC port. EEE Ы ЧАИ à
« [ryto select other port and then USER G КАМА
switch back. NAARMIN GN! This equipment generates, Uses, and can
- Exchange other keyboard. radiate radio frequency energy and If not installed and
- Connect the keyboard to PC directhy, Used in accordance with the instructions MANUAL,
Keyboard Hangéd |- ExchangethePCport. may cause interference to radio communications. It has
- Iryto select other port and then been tested and found to comply with the limits for a
Sei ak Class A computing device pursuant to Subpart | of part
- Do not move keyboard mouse or 15 of FLL Rules, which are designed to provide
entire iad reasonable protection against such interference when
Imbroner Oneration |” Adiust the dip switch. operated ina commercial environment. Uperations of Please read this manual thoroughly and follow the
Rp Р ЭНЕН Fis turned off for this equipment In a residential area |5 likely to cause instruction procedures to prevent any damage tothe
| interference in which case the user at his own expense i
- Tryto select other port and then | | CPU SWITCH andorthe connecting devices.
switch Back. will be required to take whatever measures may be
required fo correct the interference,
Function SPECIFICATION After the computers are turned on, the front panel shows:
Model { P5/2 } EK-PS2C ЕК-РА2С PC1/PC2 LED : The LED will beit for the PO which Is
Description 2 PCs to 1 User selected or scanned.
Case design PLASTIC CASE AUTO LED : it's on manual mode when turn on the
PC selection method LED will not be lit.
Keyboard Hot Kays y — NE
Adjust t
sar Rate 5 sec / 10 sec / 15 sec 1.First turn on the monitor followed by the KVM switch, —
SPELT ON Ee E 1. 5 sec, inoriginal desion
dou 8 HO 15M 32 Make sure each PC is boot-Up completely before | | = J — 3
PC side connectors MD-6M À dons % switching the KY Mi switch, 2. Press | Lock Lock | into the Auto Scan mode,
3.5 Che plug x > rm
ко = = rats tha 3,Press |+ |or| — | tao choose the scan rate,
HD-15F x 1 EN TA
Console side connector | ¡un ¿E y 9 MD-6FXx2
35) phonejackx 1 TT rm. scroll scroll ERE a de ss
Audio Support МО YES OL ос
5 5ес, OFF OFF ОМ
Transmission Distance = TORE on OFF CFE
PC side to Switch E 15 sec, ON OFF ON
Console sida to Switch 3mMeter TT CE E SR
Press onthe keyboard, |
CAE = Molding with 12m Coaxial cable ESC Te я =
rica quency 43-250Hz —
Max. Resolution 1920x 1440 lo select PC: == = = —
Video Bandwidth 25 ОМНЕ *Note:f the power was turned off the scanrate will
Hat a crol scroll *
Horizontal Frequency 20: 100KH= ot Key operation: Fock Cané ESC back to the default setting-5 seconds,