Transcript
Memory Module Specification KVR266X64SC25/1G 1GB 128M x 64-Bit DDR266 CL2.5 200-Pin SODIMM DESCRIPTION: This document describes ValueRAM's 128M x 64-bit (1GB) CL2.5 SDRAM (Synchronous DRAM) DDR266 memory module. The components on this module include sixteen 64M x 8-bit (16M x 8-bit x 4 Bank) DDR266 SDRAM sealed in TCP packages. This 200pin DIMM uses gold contact fingers and requires +2.5V. The electrical and mechanical specifications are as follows: FEATURES: Clock Cycle Time (tCK) Row Cycle Time (tRC) Refresh Row Cycle Time (tRFC) Row Active Time (tRAS) Single Power Supply of Operating (IDD0) UL Rating 7.5ns (min.) / 12ns (max.) 65ns (min.) 75ns (min.) 45ns (min.) / 120,000ns (max.) +2.5V (+/- .25V) 3.900 W 94 V - 0 Note: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. However, in no configuration will the module height exceed 1.250" (31.75mm). 2.66 (67.60) 2.50 (63.60) 39 41 0.456 11.40 0.086 2.15 1.896 (47.40) 2-f 0.07 (1.80) Units : Inches (Millimeters) Z 0.098 2.45 2 199 0.17 (4.20) 0.096 (2.40) 0.07 (1.8) 0.79 (20.00) 0.24 (6.0) 1 1.25 (31.75) Full R 2x 0.16 ± 0.039 (4.00 ± 0.10) 40 42 Protective Cover Y 200 Protective Cover Tolerances : ±.006(.15) unless otherwise specified Figure 1: KVR266X64SC25/1G 200-Pin DDR266 Document No. VALUERAM0294-001.A00 04/28/03