Download Pyle Amplifiers User Manual

Owner's Manual
PDBC10
-
<S;:'''l>PYLE"
~~~E·
PRO
. . . .
0
0
••
""
••
""
••
0
0
••
"0
••
00
••
""
••
00
••
~
=
PDBCID
8 Outlet Rack Mount Power Supply Center
-
OPERATION NOTICE
Thank you for buying our product. Please take a few minutes to read these
operating instructions. These instructions have important product information,
explaining the features and operation of your unit. Please retain these
instructions for future reference.
1. Be sure that the line voltage of your
outlet isAC IIOV/60HZ or 220V/50HZ. If
you aren 't sure, consult your appliance
dealer or local power company.
6. Make sure your unit is exposed to air -- do not
operate it in a smaller container or near a heater.
2. Protect the voltage line: Avoid putting pressure
on the line. Do not push or pull the line too hard.
3. Do not cover the vents: this product uses vents
to keep the temperature of the components low.
Covering the vents will damage the unit.
7. Do not drop metal in the unit. This could
cause a short-circuit and damage your
equipment.
4. Avoid water, dust, and moisture. Keep the unit
dust free and do not place liquids on or near the unit.
8. Do not open this unit. There are no
user-servicable parts inside. Please contact
qualified personnel if your unit is not
functioning.
5. Avoid putting the unit in low temperatures.
Keep the unit in a room where the temperature is
above 40 degrees Fahrenheit.
9. Do not clean with volatile solutions. Do not
use alcohol, paint, or gasoline on this product.
CONTROLS AND CONNECTIONS
PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT
Caution :To prevent malfunctioning and/or possible equipment damage:
Before plugging the unit into the power source: (1 ) the voltage selector
switch should be set for the correct voltage for your area (115Vand 230V)
and (2) all equipment connected to the crossover outputs should be turned
off and all the inputs turned off.
NOTE: Max power of each socket should below 200W
o
o
o
o
2
4
3
5
1. Power Switch 1
1&.&1
1&. &1 CE
7
6
8
5. Power Switch 5
2. Power Switch 2
6. Power Switch 6
3. Power Switch 3
7. Power Switch 7
4. Power Switch 4
8. Power Switch 8
Ef la: °lla : °lla : °lla : °lla : °lla : °lla : °lla : °1
--
2
PYLE AMPLIFIERS
3
4
5
6
7
8
1. Power output socket 8
6. Power output socket 3
2. Power output socket 7
7. Power output socket 2
3. Power output socket 6
8. Power output socket 1
4. Power output socket 5
9. Power Input Cord
5. Power output socket 4
10. Fuse
9
10
CAR AMPLIFIERS