Download SCADAPack E Conitel Slave Interface

34
SCADAPack E Conitel Slave Interface
The Post Transmission Mark parameters shown in Table 7.1 SCADAPack E Conitel Driver System
Points 33 are not brought out to the RTU Configuration software directly. In many circumstances the
default value for a port’s Post TM is sufficient (1 ms). However, if data corruption is occurring at the end
of messages, this time can be extended by setting the RTU System point for the appropriate port.
Also see communication-timing diagrams in Section Communication Timing & Protocol Select
(Communication Timing) 17 .