Transcript
INSTRUCTION MANUAL SOLAR LIGHT - SUN 508-0008 ASSEMBLY INSTRUCTIONS: This solar light is shipped with the switch in the “OFF” position. Before using the light, locate the power switch on the underside of the solar collector module and switch it to the “ON” or “AUTO” position. 1. Remove all contents from box. 2. Assemble fixture as shown on right by connecting the bottom post section the solar collector and the ground stake to the bottom of the post. 3. Install the light fixture and glass ball by threading onto the top of the post. Note that the glass ball and decorative head are shipped as two separate parts. Insert the glass ball into the center of the decorative head (sun). Insert the threaded pole top through the bottom of the decorative head and into the glass ball. Gently thread the pole into the glass ball until tight. TROUBLE SHOOTING: BATTERY REPLACEMENT: 1. Switch the On/Off switch to the “off” position. 2. Remove the four (4) screws located on the bottom of the solar panel module. 3. Remove the old battery and replace with a new battery. 4. Replace the spent batteries with new batteries, making sure the polarity is correct. 5. Re-assemble the solar light. 6. Leave the switch on the “off” position and allow batteries to charge for a full day, at which point you will need to set the switch to the “on” position* *You will only need to do this after the replacement of batteries. Note: This product uses 1 x AA NiCd battery. The rechargeable battery must be allowed to fully charge to operate properly. Partially charging the battery on a consistent basis will drastically reduce the life of the battery. Caution: Insert battery with the correct polarity. Do not mix old and new batteries. Do not mix different types of batteries: Alkaline, standard (carbon-zinc), or rechargeable (NiCd). Never short-circuit the battery terminals. Do not dispose of batteries in the fire, batteries may explode or leak. Remove batteries during long periods of non-use or when product is stored. Dispose of batteries safely. MAINTENANCE & USE: If the light does not turn on in the evening do the following: 1. Check the surrounding area for high ambient lights, such as porch lights, streetlights, etc. 2. Make sure the switch is at the “on” or “auto” position 3. Make sure solar panel is not located in a shady area, where sunlight is not reaching the unit. 4. Make sure the batteries are making contact with the terminals. (See “BATTERY REPLACEMENT,” to learn how to access battery area.) P 1. The end point of the ground stake is sharp. Do not allow children to play with the stake. 2. Wipe with soft dry cloth. Do not use any chemicals or abrasives of any kind. 3. The transparent lens on top of the solar panel assembly is sealed. Do not attempt to remove. 4. Solar lights are weatherproof, but during winter or cold temperatures (below 0ºC/32ºF), it is best to removed them and store them until extreme weather dissipated.
