Download User`s Manual

QCell-Pro One-Step qRT-PCR SuperMix Kit
020107V2
User’s Manual and Instructions
Product: QCell-Pro One-Step qRT-PCR SuperMix Kit
Catalog Number: K5055200, K5055400
Introduction
qRT-PCR is a highly sensitive technique that is widely used for detection and quantification of
RNA in tissues and cultured cells. Traditionally, quantitative PCR is performed in two steps: a
first-strand cDNA synthesis step using revers e transcript ase, followed by a PCR step using a
thermostable DNA polymerase. This Kit combines Reverse Transcriptase (MMLV-RTase) and
RNase Inhibitor in a single mixture, with hotstart Taq DNA polymerase in a separat e 2x reaction
mix optimized for probe based qRT-P CR. Both cDNA synthesis and PCR are performed in a
single tube using gene-specific primers and either cell lysate or RNA. A cell lysis buffer is
provided in the kit to make cell lysates in less than 5 minutes at room temperature. The cell lysate
can be used directly for qRT-P CR, bypassing RNA isolation proc edure. The passive reference
dye ROX is included in a separate tube to mak e the QCell-P ro One-Step qRT-P CR SuperMix
adaptable for many real-time QPCR platforms.
BioChain’s QRT-P CR SuperMix contains BioChain’s Taq polymeras e with hot start capability.
BioChain’s hot-start Taq polymerase improves PCR amplification reactions by dec reasing nonspecific amplification and preventing primer-dimer formation. This enzyme is activated after an
initial 10 minutes heating at 95°C. And the real-time RT-P CR buffer is specially formulat ed to
provide superior specificity and increase reverse transcription and amplification efficiency.
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Website: www.biochain.com
e-mail: [email protected]
1
QCell-Pro One-Step qRT-PCR SuperMix Kit
020107V2
216,
36,
6,
1
Y=-3.304Log(x)+31.88, R2=0.999, Efficiency=100.8%
Initial Quantity, Cell number
Figure 1. BioChain’s QCell-Pro One-Step QRT-PCR SuperMix provides sensitive detection down to a single cell.
K562 cells were lysed according to the cell lysis protocol. 6-fold serial dilution of cell lsyate were prepared from 216 cells
to 1 cell. GAPDH gene expression was detected using BioChain’s QCell- Pro qRT- PCR kit on Stratagene’s Mx3005P
instrument. Efficiency as measured from standard curve was 100.8%, with a R2 value of 0.999.
Features
· Flexible and convenient – quantitating gene ex pression in cells (without isolating RNA) or
RNA in one-step format
· Save time – quick cell lysis procedure, and ready-to-use supermix reducing setup time
and liquid handling steps
· High Sensitivity – qRT-PCR from as low as 1 cell or 1 pg total RNA.
· Versatile – compatible with a wide variety of cell lines
Applications
·
·
·
·
Real-Time RT-P CR
Gene expression profiling
Gene knockdown verification
Array Validation
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Website: www.biochain.com
e-mail: [email protected]
2
QCell-Pro One-Step qRT-PCR SuperMix Kit
020107V2
Description
Components in this kit are prepared with pure chemic als according to our proprietary technology.
QCell-Pro One-Step qRT-PCR SuperMix Kit provides a one-step, simple, robust, inexpensive
assay for detection and quantitative analysis of gene expression directly from cells or RNA with
probe based format.
Quality Control
1 kit of this lot has been tested for quantitating human GAPDH gene expression in a serial dilution
of cell lysate from 216 cells to 1 cell using Stratagene’s Mx3005P as a real time PCR instrument.
Good linearity and great PCR efficiency is observed and consistent with the previous lot.
Components
Catalog Number: K5055200: Reagents are sufficient for 200 assays
Item
1. Cell Lysis Buffer
2. Pro qRT-PCR Reaction Mixture, 2 x (containing
Hotstart Taq DNA polymerase)
3. Reverse Transcriptase / RNase Inhibitor Mixture
4. ROX Reference Dye
5. Nuclease-Free PCR Grade Water
Amount
20 ml
1.25 ml x 2
Part No.
K5055200-1
K5055200-2
100 ml
50 ml x 2
3 ml
K5055200-3
K5055200-4
K5055200-5
Catalog Number: K5055400: Reagents are sufficient for 400 assays
Item
1. Cell Lysis Buffer
2. Pro qRT-PCR Reaction Mixture, 2 x (containing
Hotstart Taq DNA Pol ymerase)
3. Reverse Transcriptase / RNase Inhibitor Mixture
4. ROX Reference Dye
5. Nuclease-Free PCR Grade Water
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Amount
40 ml
1.25 ml x 4
Part No.
K5055400-1
K5055400-2
100 ml x 2
50 ml x 4
3 ml x 2
K5055400-3
K5055400-4
K5055400-5
Website: www.biochain.com
e-mail: [email protected]
3
QCell-Pro One-Step qRT-PCR SuperMix Kit
020107V2
Reagents and Equipments Required but not Supplied in this Kit:
2+
2+
1. PBS (Ca , Mg free)
2. Spectrofluorometric thermal cycler
Storage and Stability
Upon rec eipt, store all components at -20 ºC in a constant temperature freezer. A void repeated
freeze/thaw cycles. When stored under these conditions the supermix is stable for one year after
ship date. The ROX reference dye is light sensitive and should be kept away from light whenever
possible.
Protocol
Primer and Probe Design
Design QPCR primers to generate amplicons of 150 bp. Since the cell lysate contains genomic
DNA, the primers and probe should be designed to amplify cDNA but minimize amplification of
genomic DNA. It is useful to choose primers or probe that span an exon-exon boundary in the
target mRNA, or choose primers that flank a large intron. If possible, design primers and probe to
avoid regions of secondary structure in the mRNA. Since reverse transcription and PCR are
performed in one-step, we recommend to use the reverse PCR primer as the gene specific primer
for reverse transcription.
Recommended Control Reactions
No Template Control (NTC): no-template control reactions are recommended in each experiment
to screen for contamination of reagents or false amplification.
No-RT Cont rol: no-RT control reactions are recommended for each experimental sample by
omitting reverse transcriptase from the reaction. The no-RT control should generate no signal if
the primers are specific for the cDNA and does not amplify genomic DNA.
Use of the ROX Reference Dye
ROX reference dye is included in this kit and may be added to compensate for non-PCR related
variations in fluorescenc e. Addition of the reference dy e is optional. Optimizing the ROX dye
concentration wit hin the qP CR reaction is an important aspect of setup. Too much ROX in the
qPCR reaction will reduce background but also makes a low target signal difficult to distinguish
from background. Conversely, too little ROX can increas e background, meaning that low or weak
target signals can be lost. For instruments that allow excitation at ~584 nm (such as Stratagene’s
Mx instrument and ABI 7500), firstly 1:10 dilut e the ROX reference dye provided in the kit, then
begin optimization using 0.5 ml diluted ROX reference dye in 25 ml qRT-P CR reaction. For
®
®
instruments that do not allow excitation near 584 nm (such as ABI PRISM /GENEAmp 5700
instruments), begin optimization using 0.5 ml undiluted ROX reference dye in 25 ml qRT-P CR
reaction.
Reagent Preparation and Storage
Thaw the tube containing 2x qRT-P CR Reaction Mixture on ice and store it on ice while setting up
the reactions.
1. If the ROX reference dy e will be included in the reaction, keep all solutions containing the
ROX protected from light.
2. Due to the sensitivity of quantitative PCR, results can be easily affected by pipetting
errors. Always prepare a master mix of qRT-P CR supermix containing the primers and
the reference dye (if reference dye is used). Individual pipetting of replicate samples is
not recommended.
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Website: www.biochain.com
e-mail: [email protected]
4
QCell-Pro One-Step qRT-PCR SuperMix Kit
020107V2
Cell Lysi s Procedure
The lysis buffer can be used to prepare lysates from a variety of mammalian culture cells.
4
Lysates may be prepared with the maximum cell density (10 cells /ml). When used for qRT-P CR,
the lysate may be diluted in the cell lysis buffer prior to adding to the qRT-PCR reaction. High
concentration of either cellular materials or lysis buffer may inhibit qRT-PCR reaction, so the total
amount of cell lysate added to the qRT-PCR reaction should not exceed 1/10 volume of the
reaction. And the number of cells added to the 25 ml qRT-P CR reaction should be <= 2,000. This
is a general guideline. For some cells lines, 2,000 cells may inhibit the qRT-PCR reaction. Prior to
the experiment, perform a pilot standard curve to determine the maximum number of the cells
that may be added to the qRT-PCR reaction, and det ermine the cell number range that give linear
amplification of the specific target under your specific reaction conditions.
1.
Harvest cells using the met hod appropriat e to the properties of the cell line. For adherent
cells, trypsinize the cells using standard techniques. Count the cell.
Pelleting the cells by centrifuging at 200 – 300x g for 5 min. Carefully remove the
supernatant by aspiration.
Wash the pellet onc e with ice-cold PBS. Pelleting the cells by centrifuging at 200 – 300x
g for 5 min. Carefully remove the supernat ant by aspiration. Keep the pellet on ice.
Add appropriate volume of Cell Lysis Buffer to the cell pellet. Vortexing for 1 minute to
lyse the cells.
Analyze the lysate by qRT-P CR. RNAs in the lysate are stable at 4°C for up to 4 hr.
2.
3.
4.
5.
QRT-PCR setup and cycling
1. Prepare the following RT-P CR reaction mixture. (First make the master mix without the
template. After making the master mix, gently mix the reaction without creating bubbles,
aliquot and then add 1 – 2.5 ml of template to each experimental reaction)
per reaction: 25 ml
Regents
Pro QRT-P CR Reaction Mixture (2x)
Reverse Transcriptase / RNase
Inhibitor Mixture
PCR forward primer
PCR reverse primer
Probe
a
ROX Reference Dye
b
Templat e (cell lysate or RNA)
Nuclease-free PCR grade wat er
Volume
12.5 ml
0.5 ml
X ml
X ml
X ml
0.5 ml
1 – 2.5 ml
Add up to 25 ml
Final Concentration
1x
150 – 200 nM
150 – 200 nM
150 – 500 nM
a
See page 4: Use of the ROX Reference Dye
If cell lysate is used as the template, the volume of cell lysate should not exceed 1/10
volume of the qRT-P CR reaction. If RNA is used as the template, it is recommended to
use RNA template in less than 1 mg.
b
2.
Gently mix the reactions wit hout creating bubbles since bubbles interfere with
fluorescence detection. Then centrifuge the reactions briefly.
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Website: www.biochain.com
e-mail: [email protected]
5
QCell-Pro One-Step qRT-PCR SuperMix Kit
3.
Place the reactions in the instrument and run the appropriate RT-P CR program. Try the
following protocol first, and optimize the reaction conditions if needed.
PCR program for RT-PCR:
Cycles Temperat ure Time
Detection Remark
1
42°C
15 min
OFF
1
95°C
10 min.
OFF
This step inactivates the
reverse transcriptas e and
activates the hotstart Taq DNA
polymerase. 10 minutes
incubation is required to fully
activate hotstart Taq DNA
polymerase.
40
95°C
15 sec
OFF
a
50-60°C
15 sec
ON
72°C
30 sec
OFF
a.
4.
020107V2
Set an appropriate annealing temperature for the primer set used.
Dissociation Program for all PCR products
Follow manufacturer’s guidelines for setting up dissociation depending on the
instrument’s software version.
Related Products
QCell-E va One-Step qRT-PCR SuperMix Kit (Cat# K5054200, K5054400), E va QP CR SuperMix
(Cat # K5052200, K5052400), Pro QP CR SuperMix (Cat# K5053200, K5053400), dNTP set for
PCR (Cat# K 6011100), PCR mix (Cat# 5051100), PCR Optimization Kit (K5051100), Taq
Polymerase (Cat#7051200), RNA, PCR ready cDNA, and PCR ready genomic DNA.
References
1. Higuc hi R, Dollinger G, Walsh P S and Griffith R (1992): Simultaneous amplification and
detection of specific DNA sequences. BioTechnology 10: 413-417.
2. Higuc hi R, Fockler C, Dollinger G and Watson R (1993): Kinetic PCR analysis: real-time
monitoring of DNA amplification reactions. BioTechnology 11:1026-1030
3. Bustin, S A (2000): Absolut e quantification of mRNA using real-time reverse transcription
polymerase chain reaction assays. Journal of Molecular Endocrinology 25:169-193.
5.
BioChain Institute, Inc.
(t) 888-762-2568 (f) 510-783-5386
Website: www.biochain.com
e-mail: [email protected]
6