Download JP handguard User Manual

Transcript
www.MadBullAirsoft.com
MAD BULL AIRSOFT
JP Hand Guard Kits for Airsoft User Manual
NOTE: WEAR GOGGLE AT ALL TIMES
Step 01:Dissemble original M4 hand guards, outer barrel, Delta ring, Step 04:Insert JP16(gas tube) into the hole on JP05(Gas Block) and
weld spring and retaining ring. Only leave “Barrel Nut.”
using spring pin to lock it, Then, put the whole set on to JP14(rear barrel)
(Please consult experts. You may need M4/M16 wrench for quick and using socket set screw and pin to fix them together
dissemble.)
Delta ring
Barrel Nut
Weld Spring
Retaining Ring
Step 02 : Install JP03(hand guard base) onto the rifle body.
Remember to line up the “gas tube” and “upper receiver” by turning
clockwise all the way down to the end and turning counter-clockwise
little bit to line up.,(If you can’t put JP03 onto upper receiver’s screws,
you may need to modify it by using one of our product: #DRM or
DRM-pro)
Step 05:Assemble JP06(compensators) on to front barrel JP15 and use
socket set screw to lock it, and use O-ring on the back end of JP15 as
washer. Then, assemble the whole set onto JP05 (Gas Block). Line up
and use socket set screw to lock it,
JP05
Step 03:Insert JP14 (rear barrel) into the hole on JP03(hand guard Step 06:Assemble JP12(hand guard) onto JP03(hand guard base) and
base) and using JP04 (delta ring) to lock it,
use 7 screws to fix onto JP03.
Step 07:Assemble JP13(upper rail) on the top of JP12(hand guard) by
screws. Assemble other rails JP07 (side rail long)/ JP09(side rail
short)/JP10(bipod base) onto your preferred position.
Product Advisory for ALL Airsoft/ Paintball related products
WEAR GOOGLE AT ALL TIMES!
WARNING:
Don’t change, obscure, alter, remove, or obliterate any coloration or markings on this gun. The
coloration and/or marking on this product, including the blaze orange barrel tip are designed to
comply with applicable state and federal law and regulations.
WARNING:
This product may be mistaken for a firearm by law enforcement officers or others. Any person
who changes, alters, removes, or obliterate any coloration or markings that are required by state
or federal law or regulation, in any way that makes this product look more like a firearm is guilty
of a misdemeanor.
WARNING:
The open display, brandishing and/or exposing of this product in any “public place” may cause
confusion and may be a crime. The term “public place” means any area opened to public,
including but not limited to, streets, sidewalks, bridges, alleys, plazas, parks, driveways, front
yards, parking lots, automobiles, whether moving or not, and buildings opened to the general
public including those that serve food or during, or provide entertainment, and the doorways and
entrances to buildings or dwellings.
WARNING:
Every person who, except in self-defense, draws or exhibits this product in a threatening manner
against another in such a way as to cause a reasonable person apprehension or fear of bodily
harm is guilty of a misdemeanor punishable by imprisonment in the county jail for a term of not
less than 30 days.