Transcript
User’s Manual SUMMARIZE The solar doorplate is a number direction board used solar energy. It can collect sunshine in the daytime and convert sunlight into electric energy,then store power in battery, the LED will light on automatically when it is dark at night. User’s Manual FIGURE AND INSTRUCTION Face Back Model no.: MS-7602 SOLAR HOUSE NUMBER insert and push up the number film along the slot. fixing hole Short jeck plug the short insert in the jeck when using, it will light on. when not using, put the short insert in the slot and seal it by glue paper Fix the doorplate on the wall by 2pcs 4x20mm round-head stainless steel bolts Short insert Insert protruding Insert concave When connecting two pieces of doorplate, just insert the protrudings of a doorplate into the relatived concaves of another doorplate and adjust them. The same way to connect doorplate more than two piece. Insert of face cover Insert of back cover When user want to change battery, must separate the face cover and back cover by knife carefully, open it and replace the old battery by new and the same standard battery in battery house, then close the face cover and back cover. Be careful not to break the wire. MAIN TECHNICAL PAREMETERS Solar panel: crystalline silicon 59.5mm×30mm 1.9V / 50mA Battery: 1pc AA 1.2V Ni - cd 600mAh Light source: Super bright LED Operating current: red, green: 10±1mA (when operating voltage is 1.3V) white,yellow,blue: 11±1mA (when operating voltage is 1.3V) Work temperature: -30°C ∼ 60°C Work humidity: 95% Weight: 100g Size: 185.8mm×75mm×19mm [email protected] made in China ATTENTION 1. When not using the doorplate, should put the short jeck in the short jeck slot and seal with glue paper and store in dark and dry place. 2. Before using or not using more than two months, to avoid damaging the battery, the doorplate should be solarized by facing sunshine for three days and charge the battery, while the short insert must be inserted in the short jeck.