Download English manual

External SATA enclosure for 2.5” SATA HDDs
EE2-SATA-1 external SATA enclosure
for 2.5” SATA HDDs
External SATA enclosure for 2.5” SATA HDDs
Disclaimer
•
We spared no efforts to make sure that the information in this manual is correct and
complete. However no liability is accepted for any errors or omissions. Gembird
Electronics reserves the right to change the specifications of the hardware and
software described in this manual without prior notice.
•
No part of this manual may be reproduced, transmitted or translated in any langua ge
in any form, by any means, without the prior written permission of Gembird
Electronics Ltd.
•
Gembird Electronics makes no warranties for damages resulting from corrupted or lost
data due to a mistaken operation or malfunction of the product, the software,
personal computers or peripheral devices.
Gembird® is a registered trademark of Gembird Europe.
Other names or products not mentioned above may be registered trademarks or
trademarks of their respective owners.
Copyright © 1997-2006 Gembird Electronics Ltd. All rights reserved.
External SATA enclosure for 2.5” SATA HDDs
EE2-SATA-1 User Manual
Introduction
Thank you for buying our external SATA enclosure for 2.5” SATA
HDDs! This manual will help you install it properly.
•
•
•
•
•
Features
Fully compatible with SATA device interface
Hot-swap, Plug-and-Play
Power switch
Aluminum case provides the best heat dissipation and hard
disk protection
High-qua lity PU leather wallet
External SATA enclosure for 2.5” SATA HDDs
Package contents
•
•
•
•
•
•
•
SATA enclosure
SATA connecting cable
Bag of mounting screws
User Manual
Driver CD
System requirements
Personal computer equipped with SATA external port
running Windows 98/ME/2000/XP
External SATA enclosure for 2.5” SATA HDDs
Driver installation under Windows98SE/M E/2000
and Windows XP
• Start the operating system mentioned above
• Insert the driver CD into your CD-ROM drive. The setup
should start automatically. If by any reason it does not,
double click the f ile "Setup EXE" from the CD
• Follow instructions on the screen to complete the setup
successfully
Now connect the product (with HDD installed) to your
computer.
Driver installation under Mac OS
If your operating system is Mac OS 8.6 or above the driver will be
installed automatica lly. If you are running an older version of OS
you will have to f irst download and setup "USB MASS STORAGE
SUPPORT 1.3.5" from the SOFTWARE SUPPORT website:
http://www.apple.com/support
Congratulation, you can enjoy this product now!
External SATA enclosure for 2.5” SATA HDDs
Warning: Before you disconnect the EE2-SATA-1 from your
system, you should always perform the following procedure:
with your right mouse button
• Click the icon
• Choose "Safely remove hardware" from the popup me nu
• After your conf irmation the message "Storage device can
now be safely removed from the system" will appear.
Only now you can disconnect the EE2-SATA-1 from the computer!