Download Wild Cat RacePace Front Bumper Installation Instructions
Transcript
DragonFire Racing 2330 W. Broadway Rd #112 Mesa, AZ 85202 1 (800) 708-9803 WWW.DRAGONFIRERACING.COM Wild Cat RacePace Front Bumper Installation Instructions Congratulations on your purchase of the new Wild Cat RacePace front bumper. Protecting the front of the Wild Cat has never looked so good. Direct bolt on and stylish as can be this is one product you don’t want to go without. Be sure to check out the rest of the bolt-on accessories in the RacePace Line. Disclaimer Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty of representation is made as to the products ability to protect the user from any injury or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise. • This is no representation this product will protect against damage in the event of collision • Do NOT use product if there is any sign of damage, fatigue, or malfunction • Intended for recreational use only • Product not intended for pulling or pushing Tools Required 17mm Wrench (2) 9/16” Wrench 13mm Wrench 10mm Socket & Ratchet T27 Torx bit Step 1: Place vehicle on flat and level surface. Place gear selector in park and remove keys from the ignition. Step 2: Remove front forward upper a-‐arm nut and install L-‐brackets securing with supplied nut. Be sure to leave loose at this time. (See Figure A & B) Dragonfire Racing Step 3: Remove two factory front lower screws that retain stock plastic. (See Figure C) Step 4: Install bumper by aligning upper tabs with L-‐brackets, secure with supplied hardware. Then secure lower bumper tubes with supplied hardware utilizing holes where screws from (Step 3) were previously removed. (See Figure D & E) Step 5: Go through and tighten all hardware (you can reference service manual for torque specs). When all hardware is secure insert tube end caps by pressing into place. (See Figure F) *Pro Tip: Be sure to check all hardware is secure prior to each ride. For further assistance please contact your authorized DragonFire dealer. Dragonfire Racing