Download TIRE PRESSURE MONITOR SYSTEM (TPMS - 350z-Tech
Transcript
Classification: Reference: Date: EL02-035a NTB02-100a February 13, 2003 TIRE PRESSURE MONITOR SYSTEM (TPMS) WARNING LIGHT FLASHES OR STAYS ON 2003 350Z (Z33), equipped with TPMS 2003 Pathfinder (R50), equipped with TPMS 2003 Murano (Z50), equipped with TPMS APPLIED VEHICLES: SERVICE INFORMATION If the TPMS Warning Light (see Figure 1) flashes or stays ON, please use the “TPMS Diagnostic Chart” (page 2) to resolve the incident. 350Z TPMS Warning Light 3 CRUISE F PATHFINDER TPMS Warning Light 2 4 E C ABS BRAK E SERVICE ENGINE SOON 40 30 F x1000 10 0 E REV 8 60 40 20 H 1 0 50 20 0 A/T OIL TEMP VDC OFF ABS BRAKE TP020443 MURANO 40 TPMS Warning light 3 2 4 5 6 x1000rpm 7 1 0 20 0 8 SERVICE ENGINE SOON SLIP VDC OFF TP030098 Figure 1 1/6 TPMS Diagnostic Chart Diagnosis Item Symptom (with key ON) Warning light immediately comes ON and turns OFF after 1 second Warning light blinks ON for 2 seconds, then turns OFF for 0.2 seconds - repeats Warning light blinks 1 time TPMS Warning Light ON 1 sec > stays OFF Blinks: Cause Action All wheel transmitters are “activated” (working) All wheel transmitters are NOT activated None (system OK) ON 2 sec > OFF 0.2 sec LF wheel transmitter is NOT activated Blinks 1 time Activate all wheel transmitters. See “Wheel Transmitter (“Wake Up”) Activation Procedure” on page 4. Activate LF wheel transmitter. See “Wheel Transmitter (“Wake Up”) Activation Procedure” on page 4. ON 0.3 sec > OFF 1.3 sec Warning light blinks 2 times RF wheel transmitter is NOT activated Activate RF wheel transmitter. See “Wheel Transmitter (“Wake Up”) Activation Procedure” on page 4. RR wheel transmitter is NOT activated Activate RR wheel transmitter. See “Wheel Transmitter (“Wake Up”) Activation Procedure” on page 4. LR wheel transmitter is NOT activated Activate LR wheel transmitter. See “Wheel Transmitter (“Wake Up”) Activation Procedure” on page 4. Blinks 2 times ON 0.3 sec > OFF 0.3 sec Warning light blinks 3 times Blinks 3 times ON 0.3 sec > OFF 0.3 sec Warning Light (instrument panel) Warning light blinks 4 times Blinks 4 times ON 0.3 sec > OFF 0.3 sec Long Term Storage Fuse pulled out Warning light comes ON and does NOT turn OFF Comes ON TPMS ECU connector pulled out Low tire pressure and or stays ON TPMS system failure Check storage fuse, see Figure 2, page 4. Install or replace (if needed). Check TPMS ECU connector. Re-connect if needed. • Perform CONSULT Self Diagnosis: - Press “Start” - Press “Tire Pressure Monitor System MENU select” - Press “Self Diagnosis MENU select” - Press “Start” • See Service Manual • Parking Lights Parking lights do NOT flash 2 times after transmitter activation. 1. Tool J-45295 battery low. Perform ID Registration if needed 1. Install new battery. 2. Ignition OFF during activation. 2. Make sure ignition is ON during activation. 3. Tool J-45295 not positioned correctly. 3. Position tool correctly during activation (see Figure 4). 4. Transmitters already activated 4. None. NOTE: If more than one wheel transmitter is NOT activated, the blinking patterns for those wheels will combine. (Example: one blink/OFF/three blinks = LF and RR transmitters are not activated.) 2/6 CAUTION (for Pathfinder & Murano ONLY): • Do NOT remove the Long Term Storage Fuse with the ignition key in the ON position. • If the storage fuse is removed with the ignition key ON, the Wheel Transmitter (“Wake Up”) Activation procedure must be done. IMPORTANT INFORMATION: I.D. Registration: • This process informs the control unit of each wheel transmitter’s location (i.e., LF, RF, RR, and LR). • Reason: The control unit must know the location of each transmitter in order to correctly relay pressure information about each tire/wheel. Transmitter (“Wake Up”) Activation: • Turns on (“Wakes Up”) each wheel transmitter allowing it to send pressure information to the control unit. The following chart shows some conditions, which may require I.D. Registration and/or Transmitter (“Wake Up”) Activation. Condition If a TPMS control unit is replaced Action Perform I.D. Registration using CONSULT-II. See the Service Manual for more information. If a wheel transmitter is replaced • Perform I.D. Registration using CONSULT-II. See the Service Manual for more information. • Perform Transmitter (“Wake Up”) Activation using Tool #J-45295. TPMS warning light is blinking or stays ON See TPMS Diagnostic Chart (page 2) for details. Note: I.D. Registration cannot be performed when the TPMS warning light is blinking or ON (in some cases). See TPMS Diagnostic Chart. 3/6 NOTES: 1) In the case of a low tire pressure condition, the TPMS warning light will come on. To turn the light OFF, do the following: • Re-set the tire pressure to the correct setting. • Drive the vehicle over 25 MPH for several minutes. 2) The wheel transmitters send updated pressure information to the control unit as follows: Vehicle parked with ignition switch ON • Updated pressure information sent every hour. * Vehicle driven over 25 MPH • Updated pressure information sent every minute. Vehicle parked with ignition switch OFF • No pressure information sent to control unit. CONSULT-II will indicate “0”* pressure. • To update pressure information quicker, drive the vehicle over 25 MPH for a few minutes. SERVICE PROCEDURE Wheel Transmitter (“Wake Up”) Activation Procedure. NOTE: This procedure must be performed using the TPMS Initialization Tool #J-45295. BEFORE YOU START: IMPORTANT INFORMATION WHEN PERFROMING THIS ACTIVATION PROCEDURE: • Do NOT remove the “Long Term Storage Fuse” (also known as the “Electronic Parts Fuse”). • Do NOT turn the ignition switch to the OFF position. • If you do either of the above, all four wheel transponders will have to be re-activated. 1. Make sure the batteries in the TPMS Initialization Tool #J-45295 are in good, strong condition. If needed, use a tester to check battery condition. 4/6 2. Confirm the “Long Term Storage Fuse” is installed in the vehicle’s fuse panel (see Figure 2). 350Z PATHFINDER 10 BAT 10A 10A 15A SPARE BAT 10A 10A ACC 15A 15A BLOWER BAT 15A BLOWER 15A ST 10A START SIGNAL IGN 10A 10A CIGAR LIGHTER MIRROR 15 15 ENG CONT INJ 10A IGN 10A HEATER MIRROR ACC 10A 15A FUSE PULLER 10 10 10 10 10 10 15 10 10 15 15 15 10 15 10 10 1. USE SPECIFIED FUSE ONLY. 2. CONTACT A NISSAN DEALER FOR SYSTEM NOT LISTED. UP SIDE IGN 10A "Long Term Storage" Fuse 15 3 20 4 15 7 10 8 7.5 12 7.5 13 15 14 10 10 17 15 18 10 19 20 10 22 10 7.5 25 15 26 7.5 28 15 29 10 7.5 SPARE TRUNK LID FUEL LID TRUNK LAMP ROOM LAMP STOP LAMP AUDIO ELEC PARTS METER O2 SEN AIR BAG ELEC PARTS "Long Term Storage" Fuse 2 15 10A CD000 10 9 10 5 10 10 10 15 7.5 20 15 23 7.5 10 15 20 IGN 15A IGN 7.5A IGN 7.5A IGN 10A IGN 10A BLOWER MOTOR AIR CON ELEC IGN ELG CONT INJECTOR B ELEC 7.5A B IGN 15A IGN 10A IGN 7.5A IGN 15A IGN 10A IGN 15A IGN 15A IGN TRANSFER 20A SHIFT BLOWER MOTOR ABS VDC TURN SIGNAL FUEL PUMP B AUDIO 15A AMP ACC MIRROR 10A B STOP 10A LAMP ACC FR 20A WIPER IGN METER 10A ACC CIG 15A LIGHTER IGN AT 10A CONT AIR BAG ENG CONT HEATER SEAT ST STARTER 7.5A ACC RR WIP 10A B BACK 10A WDW ACC AUDIO 10A B ROOM 7.5A LAMP B HAZARD 15A USE SPECIFIED UP SIDE FUSES ONLY 5W900 "Long Term Storage" Fuse "Long Term Storage" Fuse TP020441 MURANO "Long Term Storage" Fuse UP SIDE 15A ACC 15 15A 10 ACC 15 15A ST 15 10 10A 10 10 IGN 10 10 10A 10 ACC 10A 15 BLOWER BAT SPARE 10A STATER SIGNAL BAT HEATER MIRROR BAT FUSE PULLER BAT 10A 10A 10A FUEL LID METER STOP LAMP ELEC PARTS MIRROR BAT 10A RR POWER SOCKET ACC CIG 15A LIGHTER 15 IGN 15 10 10A BLOWER ACC FR POWER 15A SOCKET 15 10 CA000 1. USE SPECIFIED FUSE ONLY. 2. CONTACT A NISSAN DEALER FOR SYSTEM NOT LISTED. SPARE 15A 10 IGN 10 10A IGN 10 10A IGN 10A ENG CONT INJ IGN 10A O2 SEN METER AIR BAG ELEC PARTS TP030099 Figure 2 3. Turn the ignition switch to the ON position. IMPORTANT: The wheel transmitters must be activated in the order shown in Figure 3. Front 1 2 4 3 TP020305a Figure 3 5/6 4. Position the TPMS Initialization Tool on the tire and center it with the valve stem (see Figure 4). NOTE: Do NOT position the TPMS Initialization Tool on the wheel. NO YES PR O TO CT RE one .too PR O TO CT MS MS 529 5 TO OL one .too J-4 TP J-4 TP RE 529 5 TO OL TPMS Initialization Tool J-45295 (Do NOT hold against wheel) TP020445 TPMS Initialization Tool J-45295 (hold against tire) Figure 4 5. Press the button on the TPMS Initialization Tool and hold the tool in position until the vehicle parking lights flash twice. • This could take up to 15 seconds. • The flashes confirm the wheel transmitter (the one you are working on) is activated. 6. Perform step 5 on the remaining wheel transmitters in the order shown in Figure 3. 7. Confirm the TPMS warning light turns OFF after the last wheel transmitter is activated. 8. Turn the ignition key OFF, then ON and confirm the TPMS Warning Light does the following: • Comes ON for 1 second, then • Turns OFF and stays OFF. CLAIMS INFORMATION Submit a Primary Operation (PO) line claim using the following claims coding: DESCRIPTION Initialize Tire Pressure Warning System OP CODE PX06AA 6/6 SYM HC DIA 32 FRT 0.2 hrs