Transcript
Installation: Specifications: Model: H4 (high/low beam)/ H7 Voltage: 12VDC Lumens: 1600-1800 (H4) / 1800 (H7) per LED bulb 25W per LED bulb Power: Colour Temp: 5200K - Cool White Input: 2.2/2A ±0.1A H4 2.2A ±0.1A H7 LED Type: Cree® XLamp CXA1512 Open the dust proof cover of the light fitting Note: Please ensure your lights are angled correctly, these lights are not ADR approved. Align the snap ring to install the LED light and place the wire inside Rotate the LED light gently inside when installing the fan Instruction Manual Distributed by: TechBrands by Electus Distribution Pty Ltd. 320 Victoria Rd, Rydalmere NSW 2116 Australia Ph: 1300 738 555 Int’l: +61 2 8832 3200 Fax: 1300 738 500 www.techbrands.com Made in China Take out the existing halogen lamp after unlocking it Place the dust cover over the fitting to avoid water getting inside Connect the LED light, fan and the ballast wires together. Place the ballast near the LED light. Note: position may differ depending on the model of the car After it is installed correctly, you are now able to drive.
