Download Installation Manual For the Cartridge Filtration Combo
Transcript
FSC100, FSC150, FSC200 INSTALLATION DRAWING Cartridge Filter CF100 (For FSC100) CF150 (For FSC150) CF200 (For FSC200) Installation Manual For the Cartridge Filtration Combo Models:FSC025, FSC050, FSC075, FSC100, FSC150, FSC200 The filtration combo was packed in three carton boxes, 1.Cartridge filter; 2.Pump; 3.Mounting base and the pipes 65mm 2.0” Metric PVC Pipe (For FSC100/FSC150/FSC200) 115mm To install this filter system, you will need the following simple tools a screwdriver, 13mm wrench and PVC pipe sealant o 90 Elbow YOUR EMAUX CARTRIDGE FILTER 65mm 325mm Pump SB10 (For FSC100) SB15 (For FSC150) SB20 (For FSC200) www.emaux.com.au 1. Carefully remove the equipment from the carton and check for any evidence of damage due to rough handling or shipping. If any of the equipment is damaged, immediately notify the organization where the equipment was purchased. 2. This filtration combo should be mounted on a level concrete slab, preferable concrete poured in a form or on a platform constructed of concrete block or brick. 3. Position the cartridge filter on the mounting base so that the filter inlet (the one with union attached) is oriented near the pump mount side of the base. Secure the filter to the base with four (4) M5 screws. 4. Place the pump on the mounting base with the lint pot (or pre-filter bucket) is oriented at the round side of the mounting base, see the installation drawing in page 2 to page 4 for detail. Secure the pump to the base with two (2) or four (4) M8 bolts. 5. Remove the union/nut from the cartridge inlet and pump outlet. 6. Apply PVC pipe sealant (not included) in the pipe junction and connect the pipe and union/nut together as shown in the installation drawing in page 2 to page 4. Make sure the pipes are connected such that it would join the pump outlet and cartridge inlet together 7. Connect the filter inlet and pump outlet with the pipe connected in step 6. Make sure the o-ring is in Connected Pipe the proper position in the union. Tighten the nut to (Apply PVC pipe sealant in all the junctions) make the connection is secured EMFS10072901 4-4 1-4 FSC025, FSC050 INSTALLATION DRAWING FSC075 INSTALLATION DRAWING Cartridge Filter CF75 (For FSC075) Cartridge Filter CF25 (For FSC025) CF50 (For FSC050) 55mm 1.5” Metric PVC Pipe (For FSC075) 100mm 55mm 1.5” Metric PVC Pipe (For FSC025/FSC050) 90o Elbow 100mm 90o Elbow 55mm 285mm 55mm 260mm Pump SS033 (For FSC025) SS100 (For FSC050) Pump SC100 (For FSC075) 2-4 3-4