Transcript
LED EMERGENCY LIGHT KIT SAX01-54759 Product Features Intelligent automatic recharging function Automatic output current adjustment Constant current mode 3 hours emergency operation LED charge status display Deep discharge protection Test switch with self-test function Built-in compact design Suitable for LED luminaires with external driver Technical Data Technical Data EMLED3/60/3000 Rated supply voltage Frequency Input current Input power Power factor Charge current Recharge hours EM output current LED EM output voltage LED EM output power LED Ambient temperature ta Max. casing temperature tc Battery type Dimensions LxWxH Fixing centre D 240V 50/60Hz 40mA 4W 0.5 200mA 20h 400-40mA 6-60V (2-20 LEDs) 2.4W -25...+50°C 70°C Ni-Cd 3.6V 3Ah 160x38x28mm 150mm Important Notes Please ensure to disconnect with power supply when installing Please connect wires according to the wiring diagram shown below Please keep battery as far as possible from lamps/heat source when installing The LED charge indicator must be positoned where it can be seen without the need for the fitting to be removed from the ceiling or for tools to access it. This will in nearly every instance mean it must be mounted in the ceiling through its own hole. Dimensions(mm) Wiring for LED Driver 150mm 28mm 38mm 83mm 160mm Unswitch Switch L N L 250mm L N PRI LED Driver SEC 28mm Ni-cd 3.6V 3000mAh 400mm Status indication LED 400mm Test switch www.saxbylighting.com 98mm 33mm Ni-cd 3.6V 4500mAh Test Switch 250mm LED Driver Sw Sw Lin Lout Emergency Light Kit L N LED Lamp LED Indicator Battery Iss.1 12012015 Saxby Lighting Saxby Lighting Ltd. BH23 Ltd. 3PE BH23 3PE