Download Arctek 80TPS Instructions / Assembly
Transcript
10110 ZINS-9A006-00 1 Change lever handling if required; please follow instructions below.(LHR as preset) Lever in LHR position Lever in RHR position 2 Prepare door for lever control installation. Transfer the vertical and horizontal center lines from inside (exit device side) of the door to outside (trim side) of door. Use extra care if the end of the door is beveled. 6/8" (19.1mm) DEEP FOR WOOD DOOR. 3 Install lever control with exit device. FIGURE REPRESENTS LEFT HAND REVERSE DOOR 6/8" (19.1mm) DEEP FOR WOOD DOOR. RHR EDGE OF DOOR EDGE OF DOOR LHR 6/8" (19.1mm) DEEP FOR WOOD DOOR. DRILL THIS HOLE FOR CLASSROOM / STOREROOM FUNCTION ONLY 6/8" (19.1mm) DEEP FOR WOOD DOOR. DRILL THIS HOLE FOR CLASSROOM / STOREROOM FUNCTION ONLY