Download Proxxon 28690 Use and Care Manual
Transcript
Notes MIS 1 Your device does not work properly? Please read the operating instructions again carefully. If the unit is in fact defective, please send it to: PROX-Tech, Inc. 2555 Tate Blvd SE PO Box 1909 Hickory, NC 28603-1909 We will respond in a prompt and reliable manner. You can also order any necessary spare parts from this address. Important: A short description of the fault helps us to respond even more quickly. When returning a device within the warranty period, please enclose the relevant purchase receipt. Made in Germany by PROXXON GmbH, D-54518 Niersbach, Im Spanischen 18-24 Manual -2- Foreword General Safety Rules Dear Customer, Warning! Read and understand all instructions. Before putting the machine into operation, read the enclosed safety rules and operating instructions! Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Schematics 5 4 1 3 3 Save these instructions. 2 This manual comprises: • if the unit is used in a way which does not comply with the usual modes of operation, Fig. 4 • if it is used for purposes other than those mentioned in these instructions, • if the safety regulations are not observed. When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W." No warranty claims can be lodged for damage resulting from These cords are rated for outdoor use and reduce the risk of electric shock. We reserve the right for technical modifications without prior notification. Personal Safety: Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. We wish you much success with your screwdriver MIS 1. Dress properly. Do not wear loose clothing or jewelry. • insufficient maintenance. A Please observe the safety regulations for your own safety. Use only original spare parts. B 22 23 29 2 21 19 Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellry, or long hair can be caught in moving parts. B A 24 A -3- Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of electric shock. • operating errors, B Fig. 5 Water entering a power tool will increase the risk of electric shock. 16 Fig. 3 Do not expose power tools to rain or wet conditions. 17 The manufacturer will not assume liability for safe functioning 27 1 18 Do not operate the equipment unless you are fully familiar with it. Follow the instructions. Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. 5 Always keep this manual close at hand. Double Insulation eliminates the need for the three wire grounded power cord and grounded power supply system. 6 • increase the lifetime of the machine. Do not change the plug in any way. 25 • avoid malfunctions caused by faulty operation, This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. 20 6 Electrical Safety: Double Insulated tools are equipped with a polarized plug (one blade is wider than the other). 7 • help you to understand the machine, Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. 9 Using this manual will Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. 8 1 Cluttered benches and dark areas invite accidents. 28 Please note! Work Area: Keep your work area clean and well lit. 10 . . . . . . .4 . . . . . . .4 . . . . . . .5 . . . . . . .6 . . . . . . .6 . . . . . . .6 . . . . . . .6 . . . . . . .7 . . . . . . .7 . . . . . . .7 . . . . . . .7 . . . . . . .7 . . . . . . .7 11 . . . . . . . . . . . . . 13 . . . . . . . . . . . . . 12 . . . . . . . . . . . . . 1 . . . . . . . . . . . . . 14 Fig. 2 . . . . . . . . . . . . . 15 7 Fig. 1 . . . . . . . . . . . . . 26 B . . . . . . . . . . . . . 4 2 . . . . . . . . . . . . . 24 6 Foreword . . . . . . . . . . . . . . . . . . . . . General Safety Rules . . . . . . . . . . . . Specific Safety Rules for Rotary Tools Safety regulations . . . . . . . . . . . . . . . Description of the machine . . . . . . . . Legend . . . . . . . . . . . . . . . . . . . . . . . Functional Description . . . . . . . . . . . Technical data . . . . . . . . . . . . . . . . . . Operation . . . . . . . . . . . . . . . . . . . . . Clamping, changing tools . . . . . . . . . Connecting the machine . . . . . . . . . . Accessories . . . . . . . . . . . . . . . . . . . Care and maintenance . . . . . . . . . . . 3 A 24 1 A B Fig. 6 -4- -9-