Transcript
INSTALLATION INSTRUCTIONS Companion Wall Sconces CAUTION Read all of these instructions before installation: 1. Turn off power at fuse box before installing/maintaining/servicing/modifying the system 1. Connect wires from wall sconce to 120V power feed in junction box with wire nuts 4. Mount wall sconce to universal mounting bracket with the provided screws 2. Secure ground lead from wall sconce to ground wire or a grounded surface 5. Install lamp and turn on power 6. LAMP MUST NOT EXCEED THE MAXIMUM WATTAGE AS INDICATED ON THE FIXTURE LABEL 2. Do not install in damp or wet locations 3. Do not attempt to energize anything other than a qualified lighting fixture 4. Check with a qualified electrician before wiring 3. Secure universal mounting bracket to the junction box with 2 screws (not provided) 5. Confirm installation shall be in accordance with NEC and all local codes NOTE: If you need to shorten the pendant length, please refer to the quick pendant field cut instructions below Save these installation instructions and refer to them when additions or changes to configurations are made www.jescolighting.com