Transcript
3 EASY STEPS Create curves, corners and straight runs by simply snapping the fencing pieces together. Interlocking sections make continuous lengths. 1 Lay out fencing pieces along the area where you want to install. Be sure the fencing pieces are touching. You may want to snap them together as you proceed. See illustrations below for instructions on how to connect pieces for your desired effect. In order to make a curved section of a run, or to make a corner where the faces of two connection pieces move toward each other, you must open the slots on the female part (Fig. 1) of the hinge. You can do this with a utility knife or any other sharp knife. Remove the thin section of the piece. This is easily seen when viewing the piece from the back. When you are done, the hinge should look like Fig. 2. Do this for both top and bottom hinges on the piece. 2 Fig. 1 3 Fig. 2 Push pointed anchor posts into ground. If ground is too hard, soften it with water. If necessary, make starter holes with screwdriver. Continue fencing run. As you go, snap French Ivy-Style fencing pieces together with convenient interlocking system. Girard, PA 16417 www.emscogroup.com
