Transcript
® Front Loading Washer PRODUCT MODEL NUMBERS OVERALL DIMENSIONS 27" (68.6 cm) 50¹⁄₄" (127.6 cm) WFW8300S Electrical: 120-volt, 60 Hz, AC-only, 15- or 20-amp, fused electrical supply. A timedelay fuse or circuit breaker and separate circuit is recommended. 36" (91.4 cm) 29¹⁄₄" (74.3 cm) RECESSED AREA AND CLOSET INSTALLATIONS Recommended installation spacing for cabinet installation For cabinet installation, with a door, the minimum ventilation openings in the top are required. For closet installation, with a door, the minimum ventilation openings in the top and bottom of the door are required (view 2). Louvered doors with equivalent air ventilation openings in the top and bottom are acceptable. Washer on Pedestal 3" (7.6 cm) 48" (122 cm) 7" (17.8 cm) 7" (17.8 cm) 48 in.2 (310 cm 2) 38" min. (96.5 cm) 9" (22.9 cm) 24 in.2 (155 cm 2) 3" (7.6 cm) 1" 29¹⁄₄" 4" (2.5 cm) (74.3 cm) (10.2 cm) A 1" (2.5 cm) B 1" (2.5 cm) 27" (68.6 cm) 1" (2.5 cm) 29¹⁄₄" 4" (74.3 cm) (10.2 cm) 4" 29¹⁄₄" 1" (10.2 cm) (74.3 cm) (2.5 cm) A. Side view - closet or confined area B. Closet door with vents Stacked Washer and Dryer UNDERCOUNTER INSTALLATION Dimensions shown are the recommended spacing. 48" 2 * (310 cm2) 12" (30.5 cm) *Min. top and bottom air openings for closet door. **External exhaust elbow requires additional space. ***Wall, door and floor molding may require additional spacing. 3" (7.6 cm) 2" (5 cm) 72" (182.9 cm) 36" min. (91.4 cm) 3" (7.6 cm) 1" (2.5 cm) 24" 2 * (155 cm2) 1" (2.5 cm) 27" (68.6 cm) 1" 27" 1" (2.5 cm) (68.6 cm) (2.5 cm) 5 ¹⁄₄"** (13.3 cm) 1" (2.5 cm) 1"*** (2.5 cm) 1"*** (2.5 cm) 27" (68.6 cm) DRAIN SYSTEM OPTIONS Standpipe drain system - wall or floor (view A & B) The standpipe drain requires a minimum diameter standpipe of 2” (5 cm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute. The top of the standpipe must be at least 30” (76.2 cm) high and no higher than 96 in. (2.4 m) from the bottom of the washer. Floor drain system (view B) The floor drain system requires a siphon break that may be purchased separately. The siphon break must be a minimum of 28” (71 cm) from the bottom of the washer. Additional hoses might be needed. Laundry tub drain system (view A) The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 30” (76.2 cm) above the floor. 30" min. (76.2 cm) 30" min. (76.2 cm) A B Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. A 26" min. (66 cm) B Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. W10071770 11-07-06