Transcript
QUICK SET-UP GUIDE Mattress Pad & Blanket STEP 4 Plug Power Cord into wall Twin/Full Single control set-up STEP STEP 1 2 Power Cord Place on bed with label at foot of bed facing out Left Side Control Right Side Connect the Control Cord connector and module securely Module Label Control Cord Connector STEP 3 Run Control Cord under the bed Flag Tag BASE UNIT for REMOTE CONTROL SET-UP 4 1 Module Run Base Unit Cord 3 under the bed 2 QUEEN/KING/CALIFORNIA KING DUAL control set-up STEP STEP 1 2 Place on bed with label at foot of bed facing out STEP 4 Plug Power Cord into wall Left (Secondary) Control Connect the Control Cord connector and module securely Power Cord Left Side Right Side Right (Primary) Control (Label on back of control) Module Label Control Cord Connector Flag Tag STEP 3 Run Control Cord under the bed For questions or support, please visit www.sunbeambedding.com. © 2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
