Download Sioux Tools 5978 User's Manual

Model 5978
Operator Instructions
Form # Z568
Date 9-59/A
Important
Includes Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling,Assembly and Safety Rules.
Read these instructions carefully beforeInstalling, operating,
servicing
or repairing this tool. Keepthese Instructions in asafe
.. . .
accessible place.
ManufacturerlSupplier
Product Type
Sioux Tools Inc.
2901 Floyd Boulevard
P.O. Box 507
Sioux City, IA 51102
U.S.A.
Tel No. 712-252-0525
118" (3 rnrn) Pencil
Air Die Grinder
-
Model No/Nos
54,000
Sycles Per Min.
SerialNo.
Fax No. 712-252-4267
Recommended Hose Bore
Size - Minimum
114 Ins
8MfM
Recommended Max.
Hose Length
30 Ft
10 M
Air Pressure
RecommendedWorking
Maximum
U s e - Safely
lasses
U s e '- Safety Boots
U s e Breathing Masks
U s e Ear Protectors
-
6.2
6.2
YES
YES
YES
bar
bar
90
90
PSI
PSI
Always Wear Safety
@
Wear HearingProtection
A Ep
Safety rules when using a 5978
Die Grinder
E3tposure
- Use accessories rated at least 54,000 RPM.
- Prolonged exposure to vibration may cause injury.
- Always when using the tool, adopt a firmfooting and/or
position and grip the tool sufficiently only to overcome
any reaction forces that may result from the tool doing
work. Do not overgrip.
-Use only correct spare parts for maintenance and
repair. Do not improvise or make temporary repairs.
Major servicing and repairs should only be carried out
by persons trained to do so.
Do not lock, tape, wire, etc. the 'OnIOff' valve in 'On'
position.
-Always shut off the air supply to the tool and open the
air regulator to exhaust the air from the feed hose
before fitting, removing or adjusting the working
attachment fitted to the tool.
- Before using thetool, make sure that a shut off device
-Read all instructions before using this tool. All
operators must be fully trained in its use and aware of
these safety rules.
Do not exceed the maximum working air pressure.
Use personal protection equipment as recommended.
-Use only compressed air at the recommended
conditions.
-If the tool appears to malfunction, remove from use
immediately and arrange for service and repair. It it Is
not practical 10 remove tool from service, then shut off
the air supply to the tool and write or
have written a warning note and ,
attach it to the tool.
Take Air From Top
If tool is to be used with a balancer or
other suspension device, ensure that
L& Spot To
Trap Water
the tool i s firmly attached to the
with Suffichl Capacity
suspension/support device.
To Maintain ~ecomhended
Working Pressure A>
-When operating the tool, always keep
Air Toot
EasyTo Reach And
EachTool Outlet
the body and particularly the hands
away from the working attachment
fixed to the tool.
-The tool is not electrically insulated.
Never use the tool if there is any
Filter Lubricator
chance of coming into contact with
live electricity.
~ecommended
Air Supply System
-
-
-
Page No 1
-
*
Figure 1